Using the Red Devil River USB to ALDL direct cable

Installing the drivers for the USB to ALDL cable


If you are using a Serial to ALDL cable skip the above video

Setting TunerPro RT to the correct COM port


Downloading a TunerPro data acquisition definition fiel and if needed updating it to v5 if needed.


TunerPro Scanner Operation


TunerPro data acquisition definition upgrade data glitch fix


USB to ALDL Cable available here if you don't have one already- https://www.fiero.nl/forum/F...061099.html#lastpost

[This message has been edited by phonedawgz (edited 04-01-2012).]

Sub'd. Going to be needing this shortly. Thank you!

I use this on my OBDI and works great.

Thanks for the write-up!

Just out of curiosity, do you know of a way to make TunerPro datalog from an ALDL cable and a wideband O2 controller simultaneously? I'm trying to avoid shelling out another $300+ for an AutoPROM.

quote Originally posted by Blacktree: Thanks for the write-up! Just out of curiosity, do you know of a way to make TunerPro datalog from an ALDL cable and a wideband O2 controller simultaneously? I'm trying to avoid shelling out another $300+ for an AutoPROM.

X2

Epic info on the glitch!!!
I thought I had a bad short/ground somewhere...until I saw that!!!!

And thanks again for the cable! Nice to see a 64-bit driver folder...

[This message has been edited by lou_dias (edited 04-02-2012).]

quote Originally posted by Blacktree: Thanks for the write-up! Just out of curiosity, do you know of a way to make TunerPro datalog from an ALDL cable and a wideband O2 controller simultaneously? I'm trying to avoid shelling out another $300+ for an AutoPROM.

Your definition file must have the wideband patch if it's available (if someone has added it). I run the 730 ecm and have to use the Moates ALDL link $80 with USB cable, $50 without and the Moates Autoprom (Ostrich will work also). That's the only way the 8F code mask will allow simultaneous datalogging and emulation.

My Zeitronix wideband controller feeds into F14 if I recall correctly and shows up in the datalog without the use of the Autoprom.

You can modify the range of the history tables, something I was not aware of when I started with TP5 and therefore missed the extremely lean spots that eventually damaged my motor. You can also add history tables to show other parameters in the menu.