I'm attempting to install a set of Kahines sails on my notch and I have a question for those who have installed these. Do you position them up to the drip rail or drop them to the edge of the body and fill the gap between the drip rail and the panel? If I push it flush with the drip rail there is a gap at the bottom.


Thanks

I removed the drip rails from my Formula, so there is a small gap between the panel and the roof. I also left a little gab at the bottom.

Some pics






------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 |Work done 11-12 |Work done 12-13 |4.9 Swap |Parts for sale

[This message has been edited by falcon_ca (edited 12-06-2012).]

You dont fill the gap at the top. Leaving that gap allws the air in the cabin to flow through like a stock sail does. The gap is small.

[This message has been edited by 2.5 (edited 12-07-2012).]