***95 Camaro 3.4 swap, Ported and polished heads and intakes, CRX CAI, Custom Cam, AFP Regulator, steel vacuum lines, steel braided EGR tube, new Wire Harness, New Exhaust, No Cat, Flowmaster, polished poly dog bone. Isuzu 5 speed, Short through shifter ***Intrax 2" drop springs, Full Polly Suspension, Sencetrack Struts and Shocks, Grand AM brake upgrade, steel braided brake lines, 17" Gun Metal Wheels, Khumo Tires ***Racing Seats, SunPro tach w/ shift light, White face guages, carbon fiber Steering wheel, Carbon Fiber dash accents and custom sphere shift knob,
IP: Logged
08:48 PM
madcurl Member
Posts: 21401 From: In a Van down by the Kern River Registered: Jul 2003
Where you think, Curly? Under the vent? or somewhere else?
right near the rear quarter panel in front of the rear tire above the stock rocker side panel IMO. Or just get a rear deck vent and place it on the side of it. Thats were I'm putting mine. The second choice was where I mentioned to put yours.
The only other area is on the rear bumber just below the stock GT logo on the right side.
oh yeah, I'm using the Northstar 4.6 badge. The deck vent allow just enough room to but them there on the side and allow for a visual through the sail panels.
------------------
[This message has been edited by madcurl (edited 05-04-2004).]
IP: Logged
09:03 PM
The Aura Member
Posts: 2290 From: Winnipeg, Manitoba, Canada Registered: Nov 2001
place them on the rear lower quarter panel in front of the rear wheel, just like the "Bertone" labels on lambos from the 80's. OR on the lower rocker ground f/x behind the FRONT wheel.
pic # 1 is kinda understatingly HOT.....NOone would miss it checkin out your car and it goes the best with the lines....The second set....again, # 1 you get that Ferrariish exotic flare.....
bump cause you all have me even more undecided now
heheheehhe. It took me just two days to figure out where to place mine. I asked (2) people plus me, myself. and I. For me...It's going on the side of the rear deck modified vents once the car is painted. If I didn't have deck vents...I would keep the badges off.
Which is just one of the resons why your having a hard time deciding? Its simple once you add a different mold like the IRM or Doug's new side vent then and adding a badge is the lease of your decisions.
IP: Logged
05:52 PM
May 7th, 2004
Fastback 86 Member
Posts: 7849 From: Los Angeles, CA Registered: Sep 2003
and i hope you don't have that scoop on the back of your car FB..? 
