its been a while since i was at a fiero shin-dig, as long as i dont have to bring a fiero i could make some sunday (or sat if its after 3pm). both fieros need some work before i can take them to another one. what are you thinking of?
------------------ 1986 Silver 5 speed Fiero 3.4 DOHC Bored .30, Fully balanced and blueprinted 13.93@101mph as it is on the street. ... ... ! 350ci 400hp/tq SBC, 4 bolt main Spec Stage 3, Nitrous Oxide, many extras. 87 GT 5-speed Getrag, power everything.
IP: Logged
03:34 PM
1984whitesc Member
Posts: 1043 From: Clayton, WI USA Registered: Jun 2006
hey do you guys mind if I tag along.... maybe I can bring my new toy
What would we do... if this does happen? BTW Synthysis I got my e-brake to work. lol The cables were streched, and replaced the rear calipers. (not to hijack the thread)
[This message has been edited by 1984whitesc (edited 02-07-2007).]
IP: Logged
03:49 PM
Fiero STS Member
Posts: 2045 From: Wyoming, MN. usa Registered: Nov 2001
Steve I do not have a head laying around. Igot rid of most of the engine stuff after the last swap and parts car. I do have a complete runner sitting that I took out of the naked car to install the 40k mile engine I got from Ricks car. Looks like weekends after the 10th we could do ether Sat or Sunday.
IP: Logged
03:28 PM
fierohoho Member
Posts: 3494 From: Corner of No and Where Registered: Apr 2001
If STS has a running Engine he would be willing to part with in the Spring or earlier for a reasonable price.. Then I will have a head off a running 1984 for you Steve...
Lost the front main seal, and just figured I would replace the engine instead.
AFAIK I'm not available for at least the next 2 weekends. I'm planning on going down to Chicago (this weekend for the International Cycle Show, the following weekend for the Midwest Fiero Clubs Annual "Council" meeting). So I'm definitely not up for anything until at least the weekend of the 24th... also I believe Kev is coming with both weekends, and Marty (and possibly Eric) the 2nd weekend (16th/17th).
Anyone want to T.P. Racingman24's house while he's gone?
I'm in... If everyone brings a 12 pack of Charmin Double Quilted, and a waterhose with a spray mist nozzle, we can TP it, and then make it where it won't come off... We could also build a few layers of ice up on his now (or is it non) running Fiero....
OK - consensus so far is 4pm on Saturday at the MOA...
Now, time to pick a specific meeting location! There's a Ruby Tuesday's just inside the North entrance... otherwise we could meet at "The Rotunda" area (in front of Barnes & Noble)...
OK... that's enough votes for me! The Rotunda it is (then we can decide on dinner wherever after that).
Best way to get into the Rotunda is to park on the East side parking ramp and go into the mall - then down to the main floor. Look for us in front of Barnes & Noble (or Starbucks).
Jimmy - hope to see you there too! It's been awhile.
[This message has been edited by MinnGreenGT (edited 02-20-2007).]
IP: Logged
06:25 PM
PFF
System Bot
Feb 21st, 2007
fierohoho Member
Posts: 3494 From: Corner of No and Where Registered: Apr 2001
I need to get my hands on the Shifter assembly for the center console. (Just the shifter, no cables or shift knob), the reverse light switch, and the pigtail for it, the Transmission Cable brackets and slave mount.
The 4 speed slave cylinder (in good working shape) and the 4 speed transmission mount brackets that bolt directly to the transmission and the top of the tranny mounts....
Bring them with, and let me know a price.. I am going back to a 4 speed from my 5 speed to be roadworthy again.
IP: Logged
04:29 PM
Silicoan86 Member
Posts: 1614 From: Savage, MN, USA Registered: May 2004
... 
... 
!
I'll be out of the state until late, laaate sat night. Should do it on sun, everyone would be able to see that my Fiero actually runs. 
