Pennock's Fiero Forum
  General Fiero Chat - Archive
  GT nose spoilers

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


GT nose spoilers by Australian
Started on: 07-21-2007 08:22 AM
Replies: 2
Last post by: Australian on 07-21-2007 09:50 AM
Australian
Member
Posts: 4701
From: Sydney Australia
Registered: Sep 2004


Feedback score: (3)
Leave feedback

Rate this member

Report this Post07-21-2007 08:22 AM Click Here to See the Profile for AustralianClick Here to visit Australian's HomePageSend a Private Message to AustralianDirect Link to This Post
I have just purchased new side skirts aftermarket
Non photoshopped
http://www.muckup.com/sc008.JPG
http://www.muckup.com/sc009.JPG
Images below are photoshop but is roughly to scale looking at my front bumper and thinking i want to lower the side profile but not add whole skirt to front. Hall of famer Madcurl did it but i am looking to see if someone has premade pieces. As i dont have access to local parts so i cant hack up bumpers and fenders i wish i might try hand mould something if i cant find what i want at a reasonable price to Australia. If someone had broken bumpers front and rear id be interested in the corners. I want front just for now taking one step at a time and looking at lowering the profile of front to match my side skirts.



This images is larger than 102400 bytes. Click to view.

This images is larger than 102400 bytes. Click to view.

[This message has been edited by Australian (edited 07-21-2007).]

IP: Logged
PFF
System Bot
Newbfiero
Member
Posts: 2989
From: Canada NB
Registered: Mar 2006


Feedback score:    (19)
Leave feedback





Total ratings: 71
Rate this member

Report this Post07-21-2007 09:12 AM Click Here to See the Profile for NewbfieroSend a Private Message to NewbfieroDirect Link to This Post
Nice

IP: Logged
Australian
Member
Posts: 4701
From: Sydney Australia
Registered: Sep 2004


Feedback score: (3)
Leave feedback

Rate this member

Report this Post07-21-2007 09:50 AM Click Here to See the Profile for AustralianClick Here to visit Australian's HomePageSend a Private Message to AustralianDirect Link to This Post
I am just thinking i might paper machette my front bumpers bottom corners then pull them off make 2 moulds then fibreglass them up to make piece that i can mould to the side of the car. hmmm is that how it is done?....
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock