I found these on another forum. For those buillding your own engine mounts.

[IMG]http://i110.photobucket.com/albums/n90/Flipper_1938/HPIM1040.jpg[\IMG]

Rock Auto

small one p/n 2122 diameter: 1 1/2" height: 7/8"

big one p/n 2123 diameter: 2" height: 7/8"

Less than a $1 each.

[This message has been edited by FieroReinke (edited 01-27-2010).]

Your link is dead, but here ya go:


Joe

Are they rubber?

Thanks josef. Yes they are just simple rubber pucks that you sandwich between plates to isolate the engine or whatever else you need.

Just ordered some of these,

Didnt realize how small 2" is, glad I got the larger of the two, the rubber is moderately hard as well, not a soft squish rubber.

will these or similar fit an 86 4 cyl dogbone? I think all I really need is bushings, a bit cheaper than whole new mount

[This message has been edited by guitarjerry (edited 02-24-2010).]

im sure you can cut em down to size if you have the right tools to do so.