Ok, here goes. I have a 'gaggle' of parts already off this car and availble. I'll modify the list as parts go so please keep an eye on it as we progress. As noted above the car was an 85 GT V6 NB 4-speed. Car was red w/ gray interior. The motor and tranny are still on the cradle so that's not available yet nor is the engine wiring harness or ECM.

I am in need of a strong motor stand and/or headers for a Chevy 350 in a full size 75 pickup so a trade on a part or two is possible. That would be better for local as I need to capitalize on these parts to pay for the other car.

Anyway, the list:

door skins
rear lower 1/4 panels ( in front of the rear wheels)
firewall cover panel, grey ( the panel behind the seats)
air box
fuel filler tube
gray seats ( passenger seat cover is a bit rough) could remove covers and sell those instead of the seats if you're interested in them that way
rear deck lid ( spoiler holes)
notchback panel
entire wiring harness from front firewall forward (includes grommets, relays (when possible) and connectors. labelled !!
HVAC control (AC car)
radio console/HVAC bezel (SOLD to Eph-Kay)
complete rear wiring harness from junction near battery including connections at rear fan, tail and marker lights, cruise etc. labelled !!
center molding (grooved style)
rear interior console/ECM cover
headlight doors w/ hinges
armrests (drivers still available, passenger side sold to Eph-Kay)
rear cooling fan ( the one that blows on the alternator etc)
rear engine cooling fan ductwork
rear engine cooling tubes
gas door
rear speaker wire loom
center console skeleton (cracked and broken but may be able to be glued)
four sets of power window switches on plate (one with power mirrors switch)
pw/pdl wiring looms including door to cab flex tube
metal portion of doors including pw motors, glass, lock actuators
seatbelts (one receiver has broken plastic and support metal)
door panels
map pockets
door handle bezels w/ pdl buttons
air cleaner can
dash (a bit dry and rough)
dark gray center console outer finish piece
dash corner trim pieces (transition piece from dash to pillar covers)
radiator overflow tank w/ tube and cap (good color)
COMPLETE interior wiring harness including connectors, relays and switches etc. when possible. labelled !!!! One wire took a hit while getting it out, partially frayed but easy enough to splice a repair piece in.
gauge cluster 85 mph w/ IC loom etc.
guage cluster trim pieces
dash vents
radiator fan
NB door drip rails/gutters
complete headlight assemblies w/ motors
rear eggcrate from behind aero rear piece
rear firewall heat deflector (protects gas tubes etc)
dash speaker covers
manual mirrors
complete interior trim
inner door dew wipes
overhead light cover
carpet (good condition w/insulaton pad)
NB engine louvers
NB sail/window foundations (the piece that goes between the engine cover and the side of the NB)
front wheel well liners
rear wheel well liners
defroster ductwork
tilt steering column with cruise and intermittent wiper levers
cruise control 'coffee can'
center console carpet smoothing skirts (pieces between carpet and tunnel under the carpet)
sail panel window foundations (windows are gone but I do have the Pontiac emblems)
two front side marker lights-SOLD
two rear side marker lights-SOLD
passenger front marker light
cigarette lighter bezel
lighter element
3 ashtrays (two sold to Eph-Kay)
trans cable marked LM, 61 1/2 inches from center of connector to center of connector (auto trans?)
portions of wheel well flex skirts
wiper arms and blades
rack and pinion steering system
front calipers
rubber chin air dam with brackets
washer fluid tank w/pump and round inline fitting
front hood hinges
emergency brake lever
spare tire hold down rod
hold down bracket for jack with hold down screws
2 rear deck lid release button w/ bezel
dash filler block that looks like area when no decklid switch is installed
brake master cylinder and booster
wiper motor
radiator hold down bracket
silver A/C canister mounting between blower motor and heater core assembly
exterior door handles
oval support plates for rear stuts including nuts (these mount on the top of the strut tower, basically big washers)
grill cover that installs under the hood below the windshield
auto transmission shifter bezels (2)
blower motor
brake proportioning valve
brushed steel look guage bezel
three auto shifter handles
driver door handle bezel w/ lock lever
NOS power door lock/unlock switch
7 lug nut covers
six screw caps covering the taillight assembly screws
headlight/dimmer control switches in bezel
ECM vent grills (1 pair in silver, 1 pair in blue)
spare tire well w/ fasteners
gas tank center brace
radiator hoses
coolant tubes -very good condition !
gas tank sending unit
cowl to ground drain-the flexible rubber tube that drains the cowl in front of the window to the ground past the HVAC
plastic nut in door for upper armrest screw. (one sold to Eph-Kay, one available)
steering linkage tube from cab to rack and pinion assembly
Moonroof glass w/ hardware
moonroof frame!!!
moonroof roof panel!!!!!! (two pieces)

[This message has been edited by Copper85GT (edited 11-28-2007).]

Would you have a front GT bumper cover available? I have a set of headers for a small block chevy. They are the shorty block hugger headers and are ceramic coated.

Sorry, the front bumper cover is gone.

Can you send me a photo of the headers? I'm wondering how much repiping of the exhaust I would need.

Thanks

Tom

I need the...

-radio console/HVAC bezel
-passenger armrest, with the 3 bolts if you have them
-1 or both ashtrays

How much shipped to 64050?

edit* do you by chance also have the intake tube from the air box to the TB?

Chris

[This message has been edited by eph_kay (edited 11-04-2007).]

for the bezel you are talking about the trim piece, correct?
I'm not sure if I have the bolts for the armrest. If I do they are wire tied to it.
I believe I have both ashtrays.

I'll pull them out and weigh them for you. I should be able to get a price tomorrow that will include the shipping.

Thanks for asking.

Tom

Actually on hvac I was talking about the piece of plastic inside the metal part that holds the hvac up and holds the radio in.

And on the armrest I have 2 of the bolt, just found them, but other than the bolts I also need the piece of plastic that the top bolt of the armrest screws into.

Let me know though on everything, and on the hvac if you don't have it I will try glueing parts of it back together, but not everything is there

Chris

I found an extra tube from the air cleaner to the throttle body. Can you email me a picture of the HVAC piece you need? That would be easier.

Thanks Tom

bump

How much for the pdl set up? I will need everything except the actuators. How much shipped to 99208?
Thanks...
Jason

Stoddy, that would include the door handles, switches and wires, correct?
The pdl wiring would also include the wiring for the pw. Do you need anything for that?

I have pw now so I don't need anything there. Yup, just what you said.
Jason

front and rear side marker lights? Shipped to zip 28734? Thanks

how much for passenger side 1/4 panel w/ ground fx and the fender w/ ground fx (pass). also, how much for the resevoir (radiator overflow), the interior trim for the driver side (the one that goes along the roof and piece in between the windshield and door), pass side pw window motor and automatic locks set up for whole car, 1/4 panel molding (pass), dew wipes, pass side marker light (front), silver ecm vent grills, 1 screw cap for taillight assembly screw. If you could please pm me with the itemized prices of these items i would appreciate it very much. shipping is to 29412

Are the coolant tubes still available? PM sent.

I willl try to answer (pm) everyone's questions tonight. I won't really be available after tonight until Friday. Please bear with me. I'll get to everyone.

Thanks

Do you have the rear bumper by any chance? And if you do how much shipped to 34287.
Also how much for all the wheel liners both front and rear, I think you could roll them up to ship them.
Thanx - Dan

[This message has been edited by Cowabunga_kid (edited 11-07-2007).]

Stoddy, Eph and Tumbleweed you guys have either emails or PM's

cool w/ me

The headlight assemblies and motors, is the passenger side one still available? What kinda condition?

Sounds good.

Sounds like a plan to me.

Do you still have the engine bay vents?

Smalltown, I do have the vents available. Can I have your zip code?

Got your zip, sent you a PM

[This message has been edited by Copper85GT (edited 11-10-2007).]

Two front side marker lights rounded, not ribbed? Shipped to 77364

This was Number 800 for me
Joe

[This message has been edited by josef644 (edited 11-10-2007).]

I'm sorry but if you're talking about the black trim thru the middle all I have available is the ribbed version.

Tom

any pics yet?

Ron, got the lenses out to photograph. Between mine and my kids camera we have three with no batteries working or taking a charge. I'm going in to work in the morning and I'll send some out to you once I get home. You should see them about noon central time.

Tom

How much for the HVAC (for ac car) control, fan motor/blower, and 2 ash trays shipped to 74137? John

added some parts to the list

bump,

Lots that still has to go. My wife wants her plastic tubs back *S*

Waiting to hear from several people and hoping they haven't moved on while I was getting this stuff organized.

The list is being updated as monies are received and things are sold.

Keep those requests coming folks.

How much for the interior wiring harness and the deck lid release button/bezel?
I'm in 98296.

Thanks!

Copper85GT, I didn't get your pm and I don't know if you got mine (still trying to figure this stuff out) but I only get to see this forum during work hours through the week. If you would please try agein

Tom, Got them. Thank you. Will send money as per email. Ron

bump

To everyone who has asked about parts. I will be getting back to you either tomorrow or by the end of the weekend. Getting anything done during the week after work is next to impossible lately. Please accept my apologies for the delay.

[This message has been edited by Copper85GT (edited 11-16-2007).]

Ravant, sent you a PM on 11-11 in case you missed it.

Everyone else. I should be caught up on answering your questions/requests just likely waiting on your response. (Ace, I'll follow up per my last message)