New Items added to the bottom of the thread!!! Sold Items removed 2/28/2008
Ok, its time to move some stuff. My car is practically complete and I don't plan on owning another Fiero, so here's all the goodies. I've tried to size the photo's as small as possible to show detail but also be user friendly to low bandwidth.
I want to clear the garage completely, so everything is very reasonably priced. Prices do not include shipping - just pm or email me for shipping estimates. I haven't even gone through the attic yet, so when I do I'll be adding a lot to the list. Here's what's available now.
** -Sold- will be put by every item no longer available. ** -Pending- will be used to show that someone is in line but has not yet purchased the item. -------------------------------------------------------------------------------------------------------------------
Left side console switches- $15 for the nicest, $10 for the other two. The one in the back is entirely black. All work fine, no gunk.
Right side console panels/various switches- $5
Front compartment jack and tire screws. $5 for the set, $2.50 apiece.
Automatic Shift Knobs- $20 leather, $5 rubber. I about fell out of the chair when I saw that the Fiero store wants $250 for a new leather knob. The Leather is well worn on the top. The leather will definitely clean up a lot with some TLC. A great alternative if you're unable to purchase a $250 knob at the moment. The rubber knob should clean up almost entirely.
Single door lock- $1
Manual door handle covers- $3 Right side mirror seal- $1 Console cap- $2
Grey Sun visors (Two sets)-$10 Both need to be recovered for best look.
Arm Rest (left, right, up, down, sideways, all of them) - $4 a piece
Face plates (Left is silver, right side are dot matrix)- $20 dot matrix (Perfect), $10 Dot matrix HVAC cover (cracked corner)
Upper gauge panel (grey)- $3 no cracks or fade
Lower gauge kick panel(grey)- $3
Exhaust manifold heatshields- $10 as are, $20 polished.
Center Hvac surround- $5 barely warped, would clean up very nicely. 87 V6 ECM tray-$5 inside surround.
V6 Intake tube- $10
Engine/ Battery Separator- $5
Ash trey's- $5 for the set. Whoever had them painted the insides black. There is no rust that I can see. The stuff on them is rain and pine needles, they got left out in the rain.
1988 2.8L V6 (120,000) miles- $120 for the whole thing. Engine overheated due to water pump failure. Would highly advise a minor rebuild/ refresh (def. a new front seal after an overheat) We drove the car into the garage off of the truck before the swap. Motor turns over fine.
Or we can piece meal it... Let me know what you guys want to do.
1988 EGR tube- $20 (No leaks)
Charcoal canister stand- $1
Dome lights- $10 (one of the plastic tabs is loose)
[This message has been edited by Emc209i (edited 03-02-2008).]
IP: Logged
01:28 PM
PFF
System Bot
88Formula327 Member
Posts: 29 From: Columbus,OH,USA Registered: Mar 2007
** -Sold- will be put by every item no longer available.
Radios- $25 per radio. I have two of the electronic volume type. All three are in perfect working order other than I'm not sure about the tape belts. I never listened to cassettes. All have EQ's. 86,87, and 88 model years.
you have two of the radio's sitting on top? the ones with the push button volume control?
IP: Logged
03:00 PM
DJCam Member
Posts: 280 From: burr ridge illinois USA Registered: Apr 2006
Are those exhaust manifold heat shields 88-specific? I didn't know there were two of them, all I know for sure mine is missing the one by the alternator. I'd be VERY interested in them if they do indeed include the one that goes by the alternator.
EDIT - PM sent.
[This message has been edited by css9450 (edited 02-18-2008).]
Originally posted by Emc209i: All year 2.8L V6's use the same exhaust manifold patterns, which means every heat shield will work.
Hmmm, now that I think of it, the one I need is the special 88-only sheild which only covered the curved "elbow" at the end of the manifold, right there by the alternator. The earlier V6s had the sheild attached to the alternator instead. Thanks, however!
IP: Logged
06:05 PM
mrjohnishome Member
Posts: 925 From: Charleston, West Virginia Registered: Jun 2005
Emc209i, I've been reading yoru build thread a lot lately, as I am in the middle of the same swap. I must say I love your choice in wheels! I just bought the same enkei's (used because they are now discontinued) and I would like to know what tires you are running. I am also interested in teh steering column. Let me know a shipped price, or I happen to have a DOHC fuel rail with 5 injectors and some other parts you might be interested in.
Hmmm, now that I think of it, the one I need is the special 88-only sheild which only covered the curved "elbow" at the end of the manifold, right there by the alternator. The earlier V6s had the sheild attached to the alternator instead. Thanks, however!
That piece is the elbow that covers the end of the manifold. I would use it over an previous heat shield; and like I said, it will fit all years. Let me reiterate that this is indeed an 88 manifold from my 1988 Formula.
Emc209i, I've been reading yoru build thread a lot lately, as I am in the middle of the same swap. I must say I love your choice in wheels! I just bought the same enkei's (used because they are now discontinued) and I would like to know what tires you are running. I am also interested in teh steering column. Let me know a shipped price, or I happen to have a DOHC fuel rail with 5 injectors and some other parts you might be interested in.
Copy cat. I'll pm you the information. You should have been able to find everything in a search.
What would shipping cost to 30338 for the steering column??
Pending but I'll let you know if that doesn't go through.
Did I get back with everyone?! My inbox is crazy right now. I've even made two excel spreadsheets to keep tabs on everyone and who's interested in what, but things are still crazy. If I failed to reply to anyone, please just send me another PM and I'll get to you immediately.
Bump to the top, I've still got some good stuff left.
IP: Logged
12:50 AM
sjmaye Member
Posts: 2468 From: Hendersonville, TN USA Registered: Jun 2003
I will take it! It is not bent is all I care? You know post office offer a priority flat rate box for 8.95 and it can be any weight just has to fit in the box they offer 2 box sizes! Let me know how you want to be payed it is $5 plus shipping correct?
[This message has been edited by FIERO JOHN-WI (edited 02-20-2008).]
IP: Logged
11:21 AM
FIERO JOHN-WI Member
Posts: 2408 From: GREENFIELD, WI, MILWAUKEE Registered: Jun 2001
All private messages have been received and replied to. I have everything and everyone cataloged. Paypal money just cleared into my banking account today(Finally!!). I'll begin shipping the things I have here at school out tomorrow, the rest will be sent out this Saturday morning.
Wow. Ok, so I shipped almost everything today with the exception of a set of taillights, Chris' order, and 3.6vvt's - we need to talk later about sending things to Alaska.....
After carrying in ,what I would remember to be, 7 loads of boxes, the girl behind the counter unhinged her jaw and passed out. I was at the UPS store for 45 minutes reading off addresses and descriptions. One clerk took her lunch break and then came back in the middle of our transaction. Anyway, I did all of this shipping while I'm working hard to finish midterms... In fact I'm about to fall asleep right now. I have some 32 tracking numbers I will send to each respective receiver in the morning. Most packages are being delivered Thursday and Friday with the exception of two or three. I apologize for any suspense or delay, please bear with.
Wow. Ok, so I shipped almost everything today with the exception of a set of taillights, Chris' order, and 3.6vvt's - we need to talk later about sending things to Alaska.....
After carrying in ,what I would remember to be, 7 loads of boxes, the girl behind the counter unhinged her jaw and passed out. I was at the UPS store for 45 minutes reading off addresses and descriptions. One clerk took her lunch break and then came back in the middle of our transaction. Anyway, I did all of this shipping while I'm working hard to finish midterms... In fact I'm about to fall asleep right now. I have some 32 tracking numbers I will send to each respective receiver in the morning. Most packages are being delivered Thursday and Friday with the exception of two or three. I apologize for any suspense or delay, please bear with.
did you run into a problem? did you ship the item? let me know whats going on thanks
MAN I HATE THIS STATE! PARCEL IS FINE SORRY FOR THE INCONVENIANCE. I HAD NO IDEA IT WAS GOING TO BE SO MUCH I THOUGH THE EXTRA 5 WOULD HAVE COVERED IT. IF YOU HAVE A GUESTAMATE OF HOW LONG IT WILL TAKE TO GET HERE IT WOULD HELP THANKS PLEASE LET ME KNOW WHEN ITS SHIPPED
I've even made two excel spreadsheets to keep tabs on everyone and who's interested in what, but things are still crazy. If I failed to reply to anyone, please just send me another PM and I'll get to you immediately. 
