I get my painted panels back either Monday or Tuesday and I am in desperate need of one of these:
Mine has a screw frozen in one of the nuts so rather than fab up a new one I'm looking for a nice replacement. I don't have much time so anything will be considered even though I would prefer the nicest available.
Thanks!
IP: Logged
02:09 PM
PFF
System Bot
Copper85GT Member
Posts: 751 From: South Elgin, IL Registered: Aug 2007
It's the backsplash plate that goes behind the gas filler neck. I need to install it before I put the rear clip back on because it attaches to the back side.
Brian
IP: Logged
02:45 PM
Copper85GT Member
Posts: 751 From: South Elgin, IL Registered: Aug 2007
On the one that I have the nut that is part of the steel housing is broken off as well. The rubber is in good condition as is the front of the piece. The rear has some surface rust but it is concealed once put together. Other than that it is in good shape. I don't know if that helps you though.
Tom
IP: Logged
11:16 PM
carnut122 Member
Posts: 9122 From: Waleska, GA, USA Registered: Jan 2004
Mine was attached to the fill tube first and the body second. It seems to be more integral to the tube but that could be due to the fact that I had taken it apart that way.
T
IP: Logged
01:32 AM
grsychckn Member
Posts: 645 From: Stafford, VA, USA Registered: May 2004
