I have a V-6 from an 86GT complete on the cradle free to a good home. I pulled the engine from a junk car and never ran it. It did turn freely. Pick up near Pittsburgh, PA. I can assist with loading. I need room in my garage, otherwise I would part it out. I will put pictures up tomorrow.
I'd be interested if the cradle is in good shape. Just found that my cradle is shot and it's putting my rear end out of alignment . if I drive it much longer like this it might break through.
Oh man, I have been lookin for a cradle for so long. And now I'm right nearby....the problem is i have no place to keep that as a college student as University of Pittsburgh. and my home being in Central Pa
IP: Logged
07:25 PM
DailyDriverGT Member
Posts: 73 From: Pittsburg, PA, USA Registered: Feb 2008
I think the cradle just needs a good degreasing, sand blasting and paint. I don't see any rust through, just surface. Let me know if you're interested.
IP: Logged
09:23 PM
86stealthfiero Member
Posts: 667 From: zanesville ohio Registered: Aug 2008
its gone, i just picked it up... thanks FieroJunkie, i appreciate it very much, hopefully i can make use of it...
-and to everybody else i dont know what im using off this just yet, if you need something specific i might not need it, i has auto tranny i dont have any real use for...
IP: Logged
09:45 PM
PFF
System Bot
Sep 6th, 2008
86stealthfiero Member
Posts: 667 From: zanesville ohio Registered: Aug 2008
i think the trans mount was what had caused my weird reverse issue i just wanted a spare trans in backup. but i also have spent so much money on the car and it just being a spare im considering selling it too. i just got done with a full rebuild on the motor but anyways the fiero gods are on your side.
.
