gold 86 v-6 4 speed with bad engine. Has alot of frame rust. The tires are like new but have been flat for a while. Has gold colored rims.
Steve
Sold stuff: 4 speed shifter deck lid recall strip proportioning valve pass. side front spindle Drivers rear wheel well liner front hood release cruise servo vacuum coffee can
[This message has been edited by 86soon3.4 (edited 11-15-2009).]
IP: Logged
11:29 PM
PFF
System Bot
gtxbullet Member
Posts: 4179 From: Pewaukee, Wisconsin, USA Registered: Apr 2008
GTX and Darksyde, I will take a look at the sails tomorrow. I can't remember how good or bad they look. I will try to take pics of them tomorrow. I think I have some sails off a previous car I junked out.
Darksyde the scoop is spoken for. Sorry
Steve
IP: Logged
11:54 PM
Darksyde Member
Posts: 611 From: Tonawanda,NY Registered: Oct 2009
Originally posted by 86soon3.4: I will take a look at the sails tomorrow. I can't remember how good or bad they look. I will try to take pics of them tomorrow. I think I have some sails off a previous car I junked out.
Thanx
quote
Originally posted by 86soon3.4: the scoop is spoken for. Sorry
No worries
IP: Logged
11:57 PM
Nov 7th, 2009
BMTFIERO Member
Posts: 1187 From: Beaumont, TX Registered: Dec 2007
GTX and Darksyde here are the sail panel pics. The gold car's are cracked top to bottom and the silver car's are scratched. I have one off a different car thou.
all mounting tabs good.
GTX, what do you need from these pictures below?
I need the lower ground effect on the drivers side on this one, sorry The bra is bolted on the front
Fieromadman...What do you need from this pic? Whuuups, this is the drivers side
IP: Logged
10:02 AM
P Mag V8 Member
Posts: 112 From: Paris,Arkansas Registered: Oct 2009
PM sent sorry I didn't get all the info in one I just forgot what all I was needing. And all the Interior parts that I asked about I would need them from the Tan interior.
Thanks Thomas
IP: Logged
02:59 PM
86soon3.4 Member
Posts: 1537 From: Sobieski,WI,USA Registered: Dec 2005
I need the part that goes between the two ball joints and control arms and the tie rod end is connected to. The spindle is a part of it. Need the passenger side front one. PM sent
What color interiour does the siver Fiero have? I am looking for a gray inner drivers side lower sill trim piece. The piece that goes around the ebake lever to the dash...
I need a passenger seat bottom in the grey color, but it must be in good to very good condition. Does the silver car have a good one? If yes, I will PM you an offer.
IP: Logged
08:05 PM
86soon3.4 Member
Posts: 1537 From: Sobieski,WI,USA Registered: Dec 2005
I know there are 2 generations of headlight motors, but are there 2 generations of headlight motor controllers? I have an '87 GT that is missing the headlight motor controller in the front drivers' side wheel well area. If the '86 controller will work in my '87, I'm interested in it.
IP: Logged
11:37 AM
Nov 14th, 2009
86soon3.4 Member
Posts: 1537 From: Sobieski,WI,USA Registered: Dec 2005