Here are some more pics, pre hood and front cover mods
Gives you a better idea of the color
Professionally appraised at $19,500 (before the last $1k of custom body mods)
350 & Archie kit of course Edelbrock 600 CFM carb Supertrapps (no cats) 5 speed low mile Isuzu poly cradle bushings Original IRM rockers TSW Hockenheim R 17" X 8" wheels Kumho Ecsta Supra 225/45 ZR17 tires 5" Fiero Warehouse wing stands Optima red top battery 910 CA (NEW!) Mr. Mikes Leather seats Tilt wheel AusFiero sub box Kenwood KDC-519 CD head stereo Kenwood KAC-819 450W single channel sub amp Kicker 10" L5 Solo-Baric Square Subwoofer Pioneer 4 X 10 Dash speakers Kenwood Excelon KFC-X468C 4 X 6 back speakers Fiero store Fiero GT floor mats Fiero store glove box Tinted windows (20%) Fiero Warehouse tinted quarter windows Partial power window/lock install done with all parts to complete the install Center pod gauges installed (not hooked up to 85 mph speedo) Custom Fiero Warehouse front cover (in primer) Custom cowl exhaust hood (in primer) Rodney's competition short shifter Rodney's Mirror bras Custom decklid vent carbon fiber/aluminum pedal covers
Extras included in sale Tyvek car cover 2 extra sunroofs 2 extra hoods (original purple one & a rougher red one w/o headlight doors) Fiero Store Mustang Scoop extra Aero SE front bumper coverSold extra Center console Sluppy hood strut kit & struts 120 mph speedo (not yet V8 calibrated) Extra RH door Purple hose cover kit Purple wire loom kit
Some of you will remember me and recognize this car, and many of you have seen it at the Dells. I've truly enjoyed building it along with meeting all of you, but have run out of passion for it. Due to some personal issues I'm looking to make a fresh start and I've gotten back into motorcycles, so I'm putting the car up for sale. The car has seen very few miles in the last few years, but I just put insurance on it and took it around the block today. I'd suggest trailering it since I have a bunch of extra goodies I'd like to send with the car.
It would likely cost over $20k to build this car.
Asking $8,500
Reduced to $5,500
Car is located in the Escanaba area in the UP of Michigan (100 miles up the lakeshore from Green Bay, WI).
reply, email, or PM with any questions, what ever you please. If seriously interested contact me for my phone number.
JD
[This message has been edited by JD86GT350 (edited 08-30-2010).]
Nice car JD! To bad you have to sell it. Good luck!
------------------
1999 GMC Jimmy 2dr 4x4..V8 swap someday. 1997 Grand Prix GTP 161k miles and going strong. 1987 Fiero Coupe 5spd For sale 1987 Fiero Coupe 5spd,Steel Wheels 1986 Fiero Base Coupe 5spd..Steel Wheels Baby! 1985 Fiero GT 3800 N/A ...3800 S/C being rebuilt now. 1984 Fiero Indy #1098 w/ Centerline Wheels,Hooker Tri-y header and Indy Scoop with Strobe's
I am not a big fan of the center sub set-ups. But I must say, yours looks like it was dun nice! Is that a double-stiched seam along the corners? Looks like it was covered well. Good job!
IP: Logged
10:12 AM
Alex4mula Member
Posts: 7404 From: Canton, MI US Registered: Dec 1999
I am not a big fan of the center sub set-ups. But I must say, yours looks like it was dun nice! Is that a double-stiched seam along the corners? Looks like it was covered well. Good job!
Thanks, honestly it does intrude a little on my shoulder, but I think its worth it It is a double-stiched seam, the guy that covered it for me was a real old school pro. The stich doesn't match Mr. Mikes, but it looks cool. Also I have the original center console as well if somebody wanted to switch it back.
thanks Seanpaul, its a stock bumper that's been modified to remove the body lines that would flow into the stock hood, emblem removed, and has a Fiero Warehouse chin spoiler added.
Judging from the look of the valve covers, it that the older 290 hp motor? How long will the Isuzu tranny hold up?
hey typhoon,
it is an older block, as evidenced by the dipstick on the LH/inside. the previous owner claimed 330 HP with the internals used in the rebuild. I'll make no such claims, but I personally believe it to be around the 300 range, so 290 is right in there. As for the isuzu, its a real low mile unit (under 20k) and I'm happy with it. I don't beat the car, but you don't own a car like this and not step on it occasionally. I'm sure it could be broken, but then again you could abuse it with a duke or a 2.8 and still break it.
thanks for the interest and questions guys, this is practically theft at this price
thanks for the offer shawn, I saw your post right away, but had to think on it a bit, so that's why it took me a while to reply. I think if you weren't on the other side of the country I might consider it more seriously, but I'll have to decline.
It is a double-stiched seam, the guy that covered it for me was a real old school pro. The stich doesn't match Mr. Mikes, but it looks cool.
