"This is a Super Duty Pontiac Fiero. (SD4) Engine is a 3.0 liter Super duty (5 main SD block, new) with SD steel crank. JE flat top pistons, MSD ignition, Ultradyne roller cam, Edelbrock 4 bbl intake with 650 cmf Holly, Aluminum head, Del West Titanium valves and keepers, Jessell roller rockers, Isky roller lifters, Manley connecting rods, Super Trapp exhaust(4 exiting center rear) etc. Very streetable. GM electronic V-8 distributor(every other hole plugged off) Super duty clutch, Etc. Runs excellent, never abused. Too much money involved. But I will tell you it is very fast. I built and installed the engine in a salvage title car before the car was finished. (It was hit in the Driver's door) After I installed the engine I was told that the body was the best that could be done. Door fits well, closes tight, but there is an slight imperfection where the body molding fits at the windshield near the top drivers corner. Driver's door window doesn't seal perfectly at the top. Otherwise body is in great condition. Car has a GT front nose with spoiler, Rare Mecham racing ground effects kit. (Probably the only one left in existence) Rear (over the car) scoop. Holly side scoops on both sides. I can sell the engine and part out the car or sell it all as a package. The car is absolutely beautiful."
edited to add some pics
[This message has been edited by gt40racer (edited 06-13-2010).]
IP: Logged
11:09 AM
PFF
System Bot
Jun 13th, 2010
gt40racer Member
Posts: 75 From: Abu Dhabi, UAE Registered: Mar 2002
