I`m still making these if anyone is interested.
Thanks, Mike
85.00 includes shipping to lower 48
Contrasting stitching,,,,,,,,,no charge
Fiero emblem...................15.00.................takes about a week longer
Deep or shallow version.....same price
I can do them in Black, Dark Gray, Light Gray and Dark Brown and Tan.
Or if you want a special color you can send me the material.

[This message has been edited by TXGOOD (edited 11-17-2010).]

can you do a black, grey, or red even, with this picture of mighty mouse and 283 /300hp somewhere on it too,

[This message has been edited by 123mmmyFIERO (edited 11-17-2010).]

I will have to see if the embroidery shop has a digitized image like that.
That`s what it takes to tell the stitching machine what to sew and the Fiero emblem cost me 65.00 to have digitized.
I will check to see if they have it in stock.
Mike

Mike, do you have vinyl that matches the lighter brown used as stock in '87. Also, I notice in your picture that the deeper holder top matches the height of the armrest, is that the way your finished product comes out? Earlier pics looked like the cupholders were taller than the armrest, which one is correct?

TY

I matched up the light Brown or Tan with an 86 and I have sold a couple of cupholders in that color with no complaints.
The pictures of the cupholder that come even with the pad are the current ones.
The first couple I made were a little taller, but I scaled them down to work better with the manual shifter.
Mike

Well, I want one. Got a pic of the bottom side? What holds the front in place? Those are the coolest thing I have seen for holding cokes in a Fiero.

I don`t have a picture of one from underneath right now, as I`m at work, but I just use the Black dust cover like on chair bottoms and they have an aluminum bar that slides underneath the shifter plate in the front and elastic straps that hook under the console edge in the back. They go right to the edge of the recessed place where the window and mirror switches are.
Mike

Hello......I just sent you a P.M. with some questions. THX

PM sent.

PM sent.

Second cup holder ordered!!!!!!!!!!!!!!!!!! These are perfect, fit and finish is perfect!!!!! Bump for great product!!!!!!! Rob

Thanks, Rob
I appreciate the kudos
Mike

Mine is now on the way. REALLY Looking forward ti it. Thanks again Mike.

I just found out I have to go back to a stock center console. This would be a great addition in black.

Mike, Any chance you could get the carbon fiber vinyl that Fiero Thomas uses and do one of these? I have one of his shifter boots as well as carbon fiber look to all my bezels from tvhydrodip (water transfer printing). Look on page 4 of my thread and see what his looks like. Thanks

------------------

Getting closer every day!

https://www.fiero.nl/forum/Forum1/HTML/080998.html

Donnie

I could if FieroThomas would tell me where he got it or if he would sell me about 1/2 a yard.
Mike

I will send him a PM and ask where he got it from or he would be willing to sell a 1/2 yard.

------------------

Getting closer every day!
https://www.fiero.nl/forum/Forum1/HTML/080998.html

Donnie

pm sent

PM sent

those look awesome, I like that much better than my current cup holder. How deep are the shallow and deep versions?

The shallow are about 1-5/8" and the deep are about 2-3/8"
Mike

Got Mine today. Even nicer than it looks in the pictures. Keep up the good work! A Must Have for ANY Fiero owner.


------------------

If you cant be good, then be Good at it!

[This message has been edited by CompYellowFiero (edited 03-22-2011).]