Looking for both left and right castings. One or two of the long bolt that goes thru the 2 trailing arms from the cradle to the casting, One or two of the bolt that goes in the long bottom trailing arm. Maybe one or two of the shorter trailing arms and maybe one of the long trailing arm.

I'm finally (after looking at this for more than a few years) going to start on my 88 rear suspension casting refurbish project. This is the common problem with the 88 rear casting and the hole the long bolt goes thru. It is slightly oversize from the factory and tends to get egg shaped over time.

------------------
Rodney Dickman

Fiero Parts And Acc's Web Page:
All new web page!:www.rodneydickman.com
Rodney Dickman's Fiero accessories
7604 Treeview Drive
Caledonia, WI 53108
Phone/Fax (262) 835-9575

quote Originally posted by Rodney: Looking for both left and right castings. One or two of the long bolt that goes thru the 2 trailing arms from the cradle to the casting, One or two of the bolt that goes in the long bottom trailing arm. Maybe one or two of the shorter trailing arms and maybe one of the long trailing arm. I'm finally (after looking at this for more than a few years) going to start on my 88 rear suspension casting refurbish project. This is the common problem with the 88 rear casting and the hole the long bolt goes thru. It is slightly oversize from the factory and tends to get egg shaped over time.

Is this what your looking for? (pic shows bearings that I already sold)

$70 + Shipping from Zip 19335 UPS/ aprox 20lbs dimensions - 29*12*12 88 Rear Suspension parts, Includes parts for both sides- trailing arms, endlinks (No Knuckles and bearings,)

quote Originally posted by Back On Holiday: Is this what your looking for? (pic shows bearings that I already sold) $70 + Shipping from Zip 19335 UPS/ aprox 20lbs dimensions - 29*12*12 88 Rear Suspension parts, Includes parts for both sides- trailing arms, endlinks (No Knuckles and bearings,)

If Rodney doesn't take these, I would be very interested.....let me know please!

PM sent Rodney.

------------------
'88 GT- 3800 Turbo 11.367@121.03mph
gmtuners.com -Build info

Found what I need. I am also looking to find if anyone has the aftermarket poly kit not installed or taken apart for the rear suspension on the 88. I need to know the ID of the steel sleeves they use in these poly kits. One would need a calipers to measure the ID.

------------------
Rodney Dickman

Fiero Parts And Acc's Web Page:
All new web page!:www.rodneydickman.com
Rodney Dickman's Fiero accessories
7604 Treeview Drive
Caledonia, WI 53108
Phone/Fax (262) 835-9575

Rodney,

I installed a poly kit on my 88 and the steel sleeves are those saved from the orignal rubber bushings.

------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 |
4.9 ongoing project | Parts for sale

quote Originally posted by timcha: If Rodney doesn't take these, I would be very interested.....let me know please!

PM sent

I've got a kit uninstalled, but I'm not sure what ID you need on the sleeves. If you tell me how to get what you need from them I'd be happy to get the info for you.

These are are the measurements (ID) that I got with my calipers:

1. 0.578in
2. 0.489in
3. 0.489in