Im looking to buy a middle intake gasket. Not the gasket between the plenum and middle intake but the one between the middle and lower. Iv notice looking though the forum that these parts go by multiple names. Just to clear that up. Or does anyone know where to buy one? I know there are a few places you can buy a whole gasket kit but I only need the one gasket as I already have all the others. Thanks

edit

[This message has been edited by herkdriver (edited 01-13-2011).]

sounds good. thanks

no luck findin on yet.

You pay the postage and I will send you one at no cost from 54302. I think it will fit into a large USPS large envelope. Either can send it prioity flat rate or regualr mail. I have a few laying around from sets that I don't need.

PM sent

So I just bought a whole gasket set to get a few specific gaskets I'm not to sure what your looking for. Not the ones between the red and silver colored plenums you want the single one between the lower silver one and the upper cover on the block or the seal between the block and the top part on the block?

between the upper and lower silver plenums

buy a "sheet of gasket paper" & make one. I've made a few with a razor knife & a "straight edge". alot cheaper & better gasket material.

ya thats what i figured i was going to half to do. But if someone had one they were not using i was going to snatch that up

Let me check my pile....... I have one $6 shipped. It is a napa gasket.

[This message has been edited by mmeyer86gt/gtp (edited 01-14-2011).]