Pennock's Fiero Forum
  The Mall - Archive
  V8 Swap Parts For Sale

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


V8 Swap Parts For Sale by josef644
Started on: 03-04-2011 02:43 PM
Replies: 18
Last post by: falcon_ca on 04-01-2011 09:27 PM
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-04-2011 02:43 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
I have a few items for sale that I purchased for my 4.9 swap. The 4.9 has died an untimely death and has been removed and scrapped.
I have taken the exhaust system apart. The ends are 2.5" except on the stainless resonator tips. They are 2.25" All items are used and have about 500 miles on them.

Sound clip of how it sounded. The engine is started at about 9 seconds onto the clip:


Muffler is SOLD SOLD SOLD
Custom made in Canada muffler single 2.5 in , duel 2.5 out. Body is 15" long, 11" tall and 4.5" thick. Cost me $125.00. $50.00 + Shipping


SOLD Pontiac 6000 drivers side 4 spd automatic CV shaft. A1 Cardone. Around $60.00 $30.00 + shipping


Sold Fiero manual transmission drivers side CV shaft. Axel fell out of the transmission part. It got a small amount of dirt in to it. less than a 1/4 teaspoon. It needs to be cleaned, greased and reassembled. Bearings did not fall out of the roller balls $20.00 + shipping


SOLD NAPA Lifetime warranty water pump. around 500 miles. Cost me $58.00 sell for $30.00+ shipping


SOLD Water pump inlet that goes behind the water pump. heater hose nipple deleted and welded up. about 500 miles. Cost me $60.00 sell for 30.00+ shipping.

[This message has been edited by josef644 (edited 03-31-2011).]

IP: Logged
PFF
System Bot
3084me
Member
Posts: 1035
From: Bucks County, PA
Registered: Apr 2005


Feedback score: (5)
Leave feedback

Rate this member

Report this Post03-04-2011 03:23 PM Click Here to See the Profile for 3084meSend a Private Message to 3084meDirect Link to This Post
I'd have to measure to make sure I have enough room, but would you consider $50 shipped for the resonator tips and the converter??

If so , could you tell me the length of the converter?

(looks like appx 4-5" diameter??) - looks like you cut it off so I can't tell the length.

Thanks,

[This message has been edited by 3084me (edited 03-04-2011).]

IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-04-2011 05:02 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
 
quote
Originally posted by 3084me:

I'd have to measure to make sure I have enough room, but would you consider $50 shipped for the resonator tips and the converter??

If so , could you tell me the length of the converter?

(looks like appx 4-5" diameter??) - looks like you cut it off so I can't tell the length.

Thanks,



The catalytic converter is 10" long, and right at 4" wide
$50.00 for the converter and the tips will work if you will pay the shipping. They will all go in a large Flat Rate box ,($15.00) in the USA
-Joe
IP: Logged
3084me
Member
Posts: 1035
From: Bucks County, PA
Registered: Apr 2005


Feedback score: (5)
Leave feedback

Rate this member

Report this Post03-04-2011 09:02 PM Click Here to See the Profile for 3084meSend a Private Message to 3084meDirect Link to This Post

Works for me. PM me your Paypal address and I'll get payment to you ASAP.

Thanks,

IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-04-2011 10:12 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
Pay Pal info sent in a PM.
IP: Logged
3084me
Member
Posts: 1035
From: Bucks County, PA
Registered: Apr 2005


Feedback score: (5)
Leave feedback

Rate this member

Report this Post03-04-2011 10:39 PM Click Here to See the Profile for 3084meSend a Private Message to 3084meDirect Link to This Post
Thx,

Payment sent for Converter and Resonator Tips.

And a bump for ya'
IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-04-2011 10:50 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
 
quote
Originally posted by 3084me:

Thx,

Payment sent for Converter and Resonator Tips.

And a bump for ya'


Got the funds, will ship them out tomorrow.
Thanks
-Joe
IP: Logged
treborerellim
Member
Posts: 261
From: York PA USA
Registered: Nov 2005


Feedback score:    (8)
Leave feedback

Rate this member

Report this Post03-05-2011 11:17 AM Click Here to See the Profile for treborerellimSend a Private Message to treborerellimDirect Link to This Post
Bump for some well deserved positive feed back.
IP: Logged
falcon_ca
Member
Posts: 1291
From: Chicoutimi, Quebec, Canada
Registered: Dec 2007


Feedback score:    (26)
Leave feedback

Rate this member

Report this Post03-05-2011 11:34 AM Click Here to See the Profile for falcon_caSend a Private Message to falcon_caDirect Link to This Post
Pm sent for the Adjustable Lateral link

------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 |
4.9 ongoing project | Parts for sale

IP: Logged
DanFiero
Member
Posts: 2815
From: Cedar Rapids, Iowa
Registered: Jul 2002


Feedback score: (5)
Leave feedback





Total ratings: 96
Rate this member

Report this Post03-05-2011 12:09 PM Click Here to See the Profile for DanFieroSend a Private Message to DanFieroDirect Link to This Post
PM sent for Pontiac 6000 CV shaft

[This message has been edited by DanFiero (edited 03-05-2011).]

IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-05-2011 12:13 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
 
quote
Originally posted by DanFiero:

PM sent for Pontiac 6000 CV shaft



PM replied, and yes it is correct for a 4T60E swap

Your shipping rates sent in a PM.

[This message has been edited by josef644 (edited 03-05-2011).]

IP: Logged
PFF
System Bot
falcon_ca
Member
Posts: 1291
From: Chicoutimi, Quebec, Canada
Registered: Dec 2007


Feedback score:    (26)
Leave feedback

Rate this member

Report this Post03-05-2011 07:55 PM Click Here to See the Profile for falcon_caSend a Private Message to falcon_caDirect Link to This Post
Adjustable Lateral link sold

------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 |
4.9 ongoing project | Parts for sale

IP: Logged
DanFiero
Member
Posts: 2815
From: Cedar Rapids, Iowa
Registered: Jul 2002


Feedback score: (5)
Leave feedback





Total ratings: 96
Rate this member

Report this Post03-07-2011 10:52 AM Click Here to See the Profile for DanFieroSend a Private Message to DanFieroDirect Link to This Post
 
quote
Originally posted by josef644:


PM replied, and yes it is correct for a 4T60E swap

Your shipping rates sent in a PM.




Payment sent
IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-07-2011 02:17 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
 
quote
Originally posted by DanFiero:
Payment sent


Got it, your stuff will ship out tomorrow.

-Joe
IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-07-2011 06:48 PM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post

josef644

6939 posts
Member since Nov 2006
All items are shipped out.
IP: Logged
DanFiero
Member
Posts: 2815
From: Cedar Rapids, Iowa
Registered: Jul 2002


Feedback score: (5)
Leave feedback





Total ratings: 96
Rate this member

Report this Post03-11-2011 10:46 AM Click Here to See the Profile for DanFieroSend a Private Message to DanFieroDirect Link to This Post
Part arrived quickly, and looks good. thanks again!!! Feedback has been left.

Dan
IP: Logged
josef644
Member
Posts: 6939
From: Dickinson, Texas USA
Registered: Nov 2006


Feedback score:    (71)
Leave feedback





Total ratings: 103
Rate this member

Report this Post03-11-2011 11:13 AM Click Here to See the Profile for josef644Send a Private Message to josef644Direct Link to This Post
 
quote
Originally posted by DanFiero:

Part arrived quickly, and looks good. thanks again!!! Feedback has been left.

Dan


Feedback returned. Be sure and remove this from your old axle and add it to your new one.
IP: Logged
MulletproofMonk
Member
Posts: 3088
From: Dayton, OH (Bellbrook, OH 45305)
Registered: Oct 2005


Feedback score:    (50)
Leave feedback





Total ratings: 78
Rate this member

Report this Post03-31-2011 02:39 PM Click Here to See the Profile for MulletproofMonkClick Here to visit MulletproofMonk's HomePageSend a Private Message to MulletproofMonkDirect Link to This Post
Bought the muffler. Posting to leave feedback.

------------------
-Brian

My 87 GT Poly Suspension Upgrade (all pics) thread
Removing the roof panel

IP: Logged
falcon_ca
Member
Posts: 1291
From: Chicoutimi, Quebec, Canada
Registered: Dec 2007


Feedback score:    (26)
Leave feedback

Rate this member

Report this Post04-01-2011 09:27 PM Click Here to See the Profile for falcon_caSend a Private Message to falcon_caDirect Link to This Post
Adjustable Lateral link received

Feedback left

Thanks

------------------
"I'm not driving too fast, . . . I'm just flying too low."

Work done 07-08 | Work done 08-09 | Work done 09-10 | Work done 10-11 |
4.9 ongoing project | Parts for sale

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock