I need the valve cover bolts that have the pin sticking out of the top, where the spark plug holder clips on.
Normally there's just one, on the back corner of the rear head.
I need 5 of them, so I can eliminate the plastic wire covers.

Thanks!

------------------
Raydar
88 4.9 Formula IMSA Fastback

Read Nealz Nuze! Praise the Lowered!

Will look tonight, I am thinking I saved those when I junked out my 4.9. I will get back to you later tonight. I might still have the wire holders also.
-Joe

Thanks Joe.

I've got the wire holders (the ones that slide down over the posts.)
I also have the flat ones that came stock on the engine, but I'm trying to remove them and just let the wires reside in the clips.

[This message has been edited by Raydar (edited 05-24-2011).]

quote Originally posted by Raydar: Thanks Joe. I've got the wire holders (the ones that slide down over the posts.) I also have the flat ones that came stock on the engine, but I'm trying to remove them and just let the wires reside in the clips.

I did the same thing on mine. I did see some of these plastic clips at A-Zone last time I was there. I guess GM used those on lots of applications.

I located 6 of these:


PM me your address and I will put them in a $5.00 flat rate box and get them off for you. I can't sell them to you as someone else mailed them to me as a freebie, and I forget now who it was. Katatak I'm thinking ?
-Joe

[This message has been edited by josef644 (edited 05-24-2011).]

PM sent.
Thanks!

Mailed off this morning
-Joe

Thank you Joe!

Wow! That was quick!
Never thought they'd be here today, but they made it.

Thanks Joe!

Good luck with your swap.
-Joe