Pulled this motor for a 3800 swap...The motor from what I was told was a 2.8 block with a 3.1 crank in it...This was was ran hot but the PO really was unsure if any damage was done...Parting out complete motor with auto trans that was working fine when the car went down. Here are some of the major parts off it that are remanned parts with less than 10K on them....

Starter--$55 shipped
Alt-------$55 shipped
Dizzy---$55 shipped

I am going to check the upper intake pieces to see if they where ported. Seems like I read that they where but have to check to make sure...Will list them once I find out....Any other parts that are needed let me know and I will check for condition and get a price....

Need a coolant fill / thermostat housing.

If its a real 2.8 Distributer engine how much for a good harmonic balancer and the timing scale behind it which is attached by 2 screws? Timing mark must be in the normal location for a 2.8 but I can still use the timing scale.

Ship zip 19320

Spoon
------------------
Two yeast spent their entire life "about 2 days" discussing what the purpose of life could be and not once did they even come close to the fact that they were making champagne. Quoted by: Unknown

[This message has been edited by Spoon (edited 09-12-2011).]

quote Originally posted by Spoon: If its a real 2.8 Distributer engine how much for a good harmonic balancer and the timing scale behind it which is attached by 2 screws? Timing mark must be in the normal location for a 2.8 but I can still use the timing scale. Ship zip 19320 Spoon

I am off tomorrow and will check on these parts and let you know....

How much for the injectors sent to 95648?

[This message has been edited by sabotage (edited 09-13-2011).]

quote Originally posted by sabotage: How much for the injectors sent to 95648?

$55 shipped....

I'm interested in the thermostat housing, throttle body and middle intake manifold. Maybe the lower intake manifold if you throw it in as a good deal.

quote Originally posted by Oslo: I'm interested in the thermostat housing, throttle body and middle intake manifold. Maybe the lower intake manifold if you throw it in as a good deal.

I have a complete 3 piece intake setup already laying around if interested in it also along with several TBs. I need to pull this setup off to see if it is a ported set or not. Pm me on what you will offer for intake/TB parts and we can work out a deal...

Bump.....

Again....

Would you happen to have a "Good Working" EGR solenoid? Shipping zip 89117.

------------------
Peace!!

B2 OUT!!
86GT 3.4LProject

quote Originally posted by BAM-BAM: Would you happen to have a "Good Working" EGR solenoid? Shipping zip 89117.

The motor I am parting was running up to being overheated and everything was good on it. I will say that the unit on this motor is good but no way to be 100%.

How much for the y pipe shipped to 30461?

quote Originally posted by 86FIFI: How much for the y pipe shipped to 30461?

Missed your post..PM sent....

do you have any shift cables for sale if so how much shipped to 48111

Thanks for the parts

I need a crank pulley and WP pulley shipped to 98001. Larry

what trans does it have?

quote Originally posted by jaredmurray88: what trans does it have?

Auto...Would be pick up only though..no shipping on it....