I have two cracked heads on my 2.8, I just need the iron heads and none of the valves or springs or anything. And my oil pan is leaking from welding too close to it. Let me know, I am located in Massachusetts. Thanks,
Zach
IP: Logged
04:56 PM
PFF
System Bot
zkhennings Member
Posts: 1931 From: Massachusetts, USA Registered: Oct 2010
I have an extra set of heads that I bought to replace a set that had some stripped exhaust manifold bolt holes. I ended up selling the engine without replacing the heads. I bought these heads on the Forum from a member that said they're from an '86 GT with 80,000 miles. I'm in Jacksonville,FL so shipping may cost a bit. Let me know if you may be interested. Feel free to make an offer.
IP: Logged
06:41 PM
Jfrost Member
Posts: 1092 From: Brookfield, IL Registered: Jul 2009
Ok here they are a set of 2.8 heads need a little clean up with a scotch brite pad, been stored in the barn loft for a few years. They have less than 500 miles after they were rebuilt, the engine spun a main so I put in a sbc. They have studs for exhaust manifolds. I think they have high lift rockers if I remember correctly.
Thanks,
Vince
[This message has been edited by Snapperhead (edited 07-02-2012).]
IP: Logged
05:55 PM
PFF
System Bot
lou_dias Member
Posts: 5348 From: Warwick, RI Registered: Jun 2000
I bought the heads from Snapperhead and they are great! They arrived pretty fast and were packaged very well with lots of foam I was very pleased with my transaction.
