I have a set of Sprint headers for the 2.8, used with a couple thousand miles on them, about 3 years old. They aren't shiny anymore, but the coating is still in good condition. Looks like some minor surface rust on the flange around the gasket as seen in the picture below. EDIT: Actually it looks like old copper spray-a-gasket, not rust. Car was always garaged, don't need anymore as I am doing a V8 swap.

New $600, asking $320 shipped via USPS.

Thanks,
Nate

[This message has been edited by NJD85GT (edited 03-29-2012).]

ahhh.... if only I had 160 bucks more.... why am I going to school again? .... lol good luck with the sale.

quote Originally posted by LaFierte: why am I going to school again?

So when you get your degree, $360 will be pocket change

Yeah true.... sept about the 10 or 20 years to pay off tuition dept XD (ok that might be a little exaggerated)....

quote Originally posted by LaFierte: Yeah true.... sept about the 10 or 20 years to pay off tuition dept XD (ok that might be a little exaggerated)....

Sure doesn't feel like an exaggeration.

quote Originally posted by LaFierte: Yeah true.... sept about the 10 or 20 years to pay off tuition dept XD (ok that might be a little exaggerated)....

But you will have a lifetime of knowledge...

PrIce reduced.

Thanks,
Nate

pm sent

PM sent with offer!

Would these work with a Fiero store Y pipe? Also can the rear header be installed without dismantling or removing the motor?

------------------

https://www.fiero.nl/forum/Forum1/HTML/087461.html

PM sent.

------------------
Nick D.
'88 Fiero GT 5-spd
'03 Jetta GLS TDI 5-spd

Sold pending, I am sorry for the delay in responses.

JCiris,
These replace the stock manifolds, and can be installed with engine in car.

Thanks,
Nate

Please PM if still available.

Nate,
You've got PayPal!

Nate,
I got them today and they look great. Thanks for the great packing job you did. I'm leaving feedback.

Thanks again,
Bob