Hey guys, I'm going to be leaving for college in a few weeks and I decided that I need to sell off some of my Fiero stuff. I'm not going to have time to install them, so if I don't sell them they will just sit in my parents garage and take up space. I'm not in a rush to sell them, but I think they will be more useful to someone else. I'm selling rocker panel scoops and a roll bar. Both items are best offer. DON'T BE AFRAID TO MAKE AN OFFER. I won't be offended. I am also interested in trading these for a motorcycle. If you need more pictures just ask and I will take some. Sorry for the poor quality on these pictures, they were taken from my phone. I am going to be gone for a little while so if I don't reply right away that is why, but I will do my best to respond quickly. I would prefer to sell local, as I have no idea how I would go about shipping these.

Rocker panel scoops: SOLD

Roll Bar:
The roll bar is made out of .120 x 1.5" DOM tubing. The floor and firewall plates are 3/16" thick. One of the bends was a few degrees off so the bar is ever so slightly crooked, but it's hard to tell unless you lay it flat on the floor. Will probably interfere with some seat travel, but I haven't installed it yet so I am not sure. If you install this, you will want to weld a metal plate over your passenger side drain plug as one of the bolts will go there. I know this will fit without a car interior (B Piller trim, Carpet, Headliner, Glove box, ect..) But I have not had it in a car with a full interior. When I made this bar I did my best to try to conform to the SCCA guidelines, But I have not taken it to a tech inspection yet. Comes with large washers and grade 8 bolts and nuts. Bar has been painted red.

[This message has been edited by Big Paul (edited 07-29-2012).]

pm sent

------------------
V/R
AG2(AW/SW) Mauk

[This message has been edited by D3M6B (edited 07-28-2012).]

PM sent

[This message has been edited by katore8105 (edited 07-28-2012).]

quote Originally posted by katore8105: PM sent

Your lucky ... I was going to buy these to put them over your head!!! Lmao

------------------

BLUE BY YOU!
NYFOC

All PM's have been replied to!

Just for a bit of into the rockers look to be archies... IRM had the molding glassed into the rocker itself... any ideas of the price on them? Coule be interested if the price it right.

Whats the asking price of the roll bar shipped to 95961?

Seen these on IAF and was going to ask about them but...

[This message has been edited by SLOWnSTEADY (edited 07-29-2012).]

quote Originally posted by pontiackid86: Just for a bit of into the rockers look to be archies... IRM had the molding glassed into the rocker itself... any ideas of the price on them? Coule be interested if the price it right.

yep, those are archies, I have IRMs on my GT and the rockers dont seem to stick out as much as archie's do. For instance my rockers are flush with the door, these would stick out an inch or two.

The side Scoops have been sold! Roll bar is still available

.

Roll bar price?

I suppose it has to go truck????