Like it says I'm doing a swap and trying to get the 3.4 as ready to go as I can. What I need is the threaded shaft off a 2.8 so the oil filter comes straight out of the block? Anyone have one they would like to part with?

I am also looking for a Alternator bracket/bolts.

[This message has been edited by Grantman (edited 03-26-2013).]

bump

if you still have the oil adapter for the 3.4 block, pull the boss of of it and screw it in the block. It just takes an allen wrench.

Hadn't looked at it that close. I thought it was threaded on one end but the other end was solid so it wouldn't work. figured what I needed had to be threaded from one end to the other and it had a 10mm hex cast inside to screw it in tight. Will have to look at noon. thanks.

Might have what you need. I know that you're in a rush, so let me put my fingers on it before committing. Don't want misunderstanding like before

agreed! Let's not go there.

sent you a pm. Thanks much.

Feedback left.

feedback left. Many thanks.