Wanting to buy a 3800 flywheel, PREFERABLY machined down to .840 or .820 (I think?) and balanced for a Series 3 SC engine

[This message has been edited by Flux (edited 04-02-2013).]

I have another NEW 3800 Camaro flywheel ..it is balanced but not machined to 0.840 but it is 1.073 ... PM me if you want it ...

------------------

My Build Thread
Tylers Toy

Go in to your local NAPA and order one... Last time I checked there was one available in Ontario..Then have it machined..

quote Originally posted by Danyel: I have another NEW 3800 Camaro flywheel ..it is balanced but not machined to 0.840 but it is 1.073 ... PM me if you want it ...

PM sent

quote Originally posted by thismanyfieros: Go in to your local NAPA and order one... Last time I checked there was one available in Ontario..Then have it machined..

Unfortunately no parts distributors in calgary seem to have a damn flywheel in stock all across canada. go figure.

What does a machined flywheel usually sell for? I see the prices for a stock thickness.

well the cost of a new/OEM flywheel + machining and balancing (varies on where you get the work done)

PM replied

payment sent.

item received. looks good!!

You are welcomed ... FEEDBACK left THX

quote Originally posted by thismanyfieros: Go in to your local NAPA and order one... Last time I checked there was one available in Ontario..Then have it machined..

What exactly do you machine and how much. I need on too for a 2000 N/A 3800. I need to tell my machine shop guy. And does the clutch pressure plate for the Fiero fit the bolt pattern on the flywheel.

[This message has been edited by Kekipi (edited 04-09-2013).]

.840 over all thickness from the clutch surface to the mounting point onto the crank and yes get the clutch for which ever Fiero manual tranny you are mating to the 3800 engine. Dan

------------------


DARN Cars now open with
Over 30 years wiring experience between cars and trade as an avionics technician in both Canadian Air Force and civilian aviation.
Over 25 years experience building and modifying cars.
Over 10 years of full Fiero engine swaps and harnesses building and still going.

Thanks Fieroflyer, So the pressure plate for the five speed being 8 1/2 compaired to the 9 5/8 flywheel will bolt up?