Few things to get rid of and to add to the final funds of my 3800 swap....
Stainless 3800 fuel lines (2 sets available)... Sold
3800SC L67 Heads, 90k~ Miles, alittle weathered but good heads, great for porting/machining or just a core... $50 + shipping ($100 shipped??)
1998 L67 throttle body (w/ IAC and TPS)... $30 shipped
Original Packard Fiero wires 94k miles, ran fine when pulled, even though not pictured the coil wire comes with it, complete... $30 shipped
Gray/black GT/SE Passenger top and bottom seat covers, works for driver side too, bottom 7/10 top 9/10... $80 shipped
Stock passenger seat belt trim. No fading or cracks and screw holes fully intact.... $30 shipped
3800 SD Headers (ebay headers)... these were pulled from a car the PO had did a REALLYY bad weld job on the crossover pipe, so that needs to be ground off and redone or clamped, its missing the parts after the exit flange, but that doesn't matter for anyone modifiying to work with a Fiero....
SOLD ------------------
86 Fiero GT 4spd - (pending L67 swap: VS cam, GenV)
98 GTP - Some mods
[This message has been edited by sco77 (edited 08-02-2013).]