Pennock's Fiero Forum
  The Mall - Archive
  WTB Decklid hold down screws

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
WTB Decklid hold down screws by johnt671
Started on: 08-16-2013 03:07 PM
Replies: 3
Last post by: sco77 on 08-16-2013 07:47 PM
johnt671
Member
Posts: 2271
From: sugarloaf pa usa
Registered: Feb 2001

Feedback score: (5)
Leave feedback

Rate this member
Report this Post08-16-2013 03:07 PM Click Here to See the Profile for johnt671Send a Private Message to johnt671Direct Link to This Post
Anyone have a pair of the wingnut type of decklid screw? I need the type that can be loosened by hand, not the screwdriver type. I need the two washers with them also. Can do Paypal. Thanks.
IP: Logged
PFF
System Bot
partfiero
Member
Posts: 6923
From: Tucson, Arizona
Registered: Jan 2002

Feedback score:    (19)
Leave feedback





Total ratings: 83
Rate this member
Report this Post08-16-2013 04:07 PM Click Here to See the Profile for partfieroSend a Private Message to partfieroDirect Link to This Post
 
quote
Originally posted by johnt671:

Anyone have a pair of the wingnut type of decklid screw? I need the type that can be loosened by hand, not the screwdriver type. I need the two washers with them also. Can do Paypal. Thanks.


I got them, $10 shipped for both.
Each includes both plastic washers.
PM if interested.

[This message has been edited by partfiero (edited 08-16-2013).]

IP: Logged
johnt671
Member
Posts: 2271
From: sugarloaf pa usa
Registered: Feb 2001

Feedback score: (5)
Leave feedback

Rate this member
Report this Post08-16-2013 06:32 PM Click Here to See the Profile for johnt671Send a Private Message to johnt671Direct Link to This Post
PM sent.
IP: Logged
sco77
Member
Posts: 711
From: MD
Registered: Nov 2011

Feedback score: (1)
Leave feedback

Rate this member
Report this Post08-16-2013 07:47 PM Click Here to See the Profile for sco77Send a Private Message to sco77Direct Link to This Post
Was getting ready to make another thread but since this exists, I need a set of them too, if anyone has any more after OP gets some let me know.

------------------
86 Fiero GT 4spd - L67 swap: VS cam, GenV. Needs exhaust (ETA 9/13) Build Progress
98 GTP - Some mods

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock