SOLD
Well guys, all good things must come to and end. And so it is with my foray into Fieros. My back just can't take the bending over, crawling under, etc. as necessary to work on it anymore.
So I'm posting it here first for my Pennocks brethern to get first dibs on it.
I have another '88 Fiero Formula that has the 3.4DOHC engine I was going to swap into the GT. Can't do it now so I'll be selling that one also.
1988 Fiero GT 5 speed w/ shortie shifter
White paint that has seen better days but still cleans up nice.
Beechwood interior
Leather seats (wear spot on driver side bolster)
Leather steering wheel (that needs cleaning)
Power windows
Power door locks
Power mirrors (Driver side power mirror stopped going in/out. Still goes up/down and passenger side works like it should. At least it did the last time I tried it. Which was right after I found the drivers not working.)
Moon roof
Glove compartment instead of the pouch.
A/C that has been changed to 132A
Upgraded Kenwood stereo/cd/mp3 player w/remote
Subwoofer in place of the center console storage pocket
New distributor last year with plugs, wires and ICM at same time
Rodney Dickman 1/2 lowering front ball joints
New water pump and serpentine belt just installed
Already had lowering springs front and back. So the front sits real low. I was going to replace the springs with stock units I have on hand. I'll include them with the sale.
I have the Hella 90mm headlights, harness, etc. but never got installed. That will be going with the car also. (The one that Synthesis was/is selling.)
Rodney Dickman shifter cables also. Never put in so they go too.
Gas gauge is correct. Fixed that when the fuel pump was replaced last year.
Fuel pump is high volume anticipating the 3.4DOHC engine swap that never occurred.
Now some of the bad: the PO put some cheesy stick on imitation wood all over that I never got around to removing. The padding right above the center gauges is not sticking anymore. The steering is a bit loose. Not bad but I've felt tighter. The PO had an alarm system that I removed most of. The wiring is still under the dash mixed in with the rest. Another project that never got started.
Temp gauge does the peg on key on thing.
Tach works sometimes. Right now it isn't working.
The PO drilled holes in front bumper to mount a license plate.
Nose badge is missing.
When the LED tail lights were installed the backup lights never were replaced.
Trunk popper still works but trunk light is burnt out.
$2500 firm
http://i272.photobucket.com...0021_zps5fca313d.jpghttp://i272.photobucket.com...0022_zps5cd30a1b.jpghttp://i272.photobucket.com...0023_zps59b85a4a.jpghttp://i272.photobucket.com...0024_zps071d5164.jpghttp://i272.photobucket.com...0026_zps7d107a27.jpghttp://i272.photobucket.com...0027_zpsdb2472e8.jpghttp://i272.photobucket.com...0028_zps99868a49.jpghttp://i272.photobucket.com...0029_zps98d6b1b3.jpgForgot to include mileage: 122,062
I'll also take pics of the trunk corners tomorrow.
[This message has been edited by n7vrz (edited 12-14-2013).]