Looking for a Front License Plate Holder for a Formula with the mounting hardware. Let me know what you got.

Thanks!

I have a bracket, but no hardware.

quote Originally posted by mrfiero: I have a bracket, but no hardware.

I am not sure how this mounts on the front of a Formula and The Fiero Store doesn't carry any screws and brackets for this.

I believe the front plate holder from a 87 Coupe should work too. If I can't find one, I may get the one you have.

Anyone?

Hey my man. I'll check around here for one.. I might have it!

quote Originally posted by Indyellowgt: Hey my man. I'll check around here for one.. I might have it!

Thanks! I really appreciate it!

Still Looking for one.

Post pictures of how it mounts, I've never seen the brackets for the 87-88 coupes.

The only one that I ever saw (removed from my Formula and gone years ago) was made out of plastic, and screwed straight into the bumper cover.

This is what I am after.

That's the one I had.
If you look carefully (or lighten up the picture) you can see the four pockets where the screws go through.
I don't think there is any hardware, other than the four screws.

quote Originally posted by Raydar: That's the one I had. If you look carefully (or lighten up the picture) you can see the four pockets where the screws go through. I don't think there is any hardware, other than the four screws.

Thanks! I wasn't sure what was in there that supports the license plate holder. I have never owned a Formula until now.

So I just need the license plate holder and the screws that hold it on the bumper.

As mentioned before, I have a nice plate frame/bracket....you just need to source some screws.

I have an 87 coupe with a front license plate. I also have an extra license plate holder that I removed from a donor car. I can take a pic of the mount and send it to you or show you if you are in the area. I assume you are in the military and need to get the car licensed in VA. If you are active duty, I'll give the holder to you. I'm between Richmond and DC.

- Jimmy

------------------
1987 coupe; Blue; 2.5L; 5-spd
1987 Firebird Formula; Blue; 5L; 5-spd

I have one you can have for free. I just need to get it back from the guy I gave it too, who never used it.

also, I put one of these on my 88 coupe, i'm still holding out that someday the VA DOT will pass the "one plate" law.

http://www.pfyc.com/GN1046.html

Rob

I bought one off of mrfiero. I gotta source some screws for it. Sucks that the Pick n Pull down there doesn't have any Fieros on the lot. But I could use some spares, especially since I plan to expand my Fiero collection once I move back to Texas and buy my own house.

I hope VA goes back to a one plate state. I don't like the look of front plates on Fieros.

Craig,

Your bracket went out today.....you should see it early next week. BTW......the bracket on that yellow Formula in the picture you posted is on upside down. Just as an FYI when you install yours, the tabs face up!