87 Coupe project (Page 4/39)
30+mpg OCT 21, 10:16 PM
Connected the brown wire from the alternator to B3 on the C500 block. Warning light on the voltmeter now works.

Whoever did the wiring on this conversion coulda done a better job.

30+mpg OCT 21, 11:13 PM
Next, to get the "check engine" light to work.
fierodustin_86 OCT 22, 05:19 AM
I just noticed that you are in the four state area, cool. Not very many of us in the area...
30+mpg OCT 22, 02:54 PM
The Service Engine Soon now comes on when the ignition is switched on.

It also goes out once the engine is started.

30+mpg OCT 28, 04:11 PM
Wired in the purple wire from the brake switch to the Brake signal input on the PCM.
Whoever did the conversion coulda done a better job of wiring.
30+mpg OCT 29, 09:04 PM
Installed a trunk release solenoid. Had to get a relay to plug in. Used a Radio Shack pushbutton switch.

Fabbed & installed a holder for front trunk light. Whoop!

Got chime to stop random dings and weak output by resoldering every connection on the back of the chime board. Works like new.

[This message has been edited by 30+mpg (edited 10-30-2005).]

30+mpg NOV 01, 09:45 PM
Installed rear side marker backing plate & a rear fender liner on the driver's side.

The guy (D. Adam Haston, 98puck on e-bay) from 2448 Forest Shadows Dr., St. Louis that sold me the liner sent me 1 left & 2 right liners. One of the right ones is a correct fit (or so I thought, NOT!). Soo, I have a spare pair for an 86 or earlier coupe once I get the correct one for the left side.

[This message has been edited by 30+mpg (edited 12-02-2005).]

Puck NOV 01, 10:45 PM
Sorry i have had those fenders for soooo long i was for sure they would fit that year model style of car.....car is looking sweet though that is alot of work put into it.

------------------

30+mpg NOV 05, 08:28 PM
Bought a 120mph Inst. panel from maxthechainsaw. Installed an Air/fuel kit in it before swapping it in.

Check
http://www.fiero.nl/forum/Archives/Archive-000001/HTML/20060206-2-068263.html
for details.

[This message has been edited by 30+mpg (edited 05-01-2006).]

30+mpg NOV 06, 04:21 PM
Used hot glue to fasten the half of the the gear display window housing to the underside of the panel that has the ashtrays.

Click on 2 below for the next page.

[This message has been edited by 30+mpg (edited 07-05-2006).]