2000 Wrangler (Page 3/3) Monkeyman MAY 11, 06:22 PM Any updates? Did you fix the door and replace the rusted fenders? Tstang429 MAY 12, 08:31 AM I have not gotten the rod fixed or fenders swapped yet. The door is going to need an entire new mechanism to be repaired. I have installed a set of fj cruiser/ hella comet 5000 series spot lights. They where sitting in the garage waiting for another project. I fixed the broken center counsel lid with the installation of t nuts from lowes. I also had the front doors tinted and as you see in that picture the windshield tint banner was installed. The tint was only 50% but that's whats legal in Ohio. Also got my Woodstock decal made and installed on the front corner. I have been soaking and working at the transfer case linkage. I got it into neutral so a little more playing I should be able to move it back to 4 low. I was given a spare cb radio by a family member that I am working on installing now as well. I will post pics once that's installed. With the nice weather moving in I have been focused on getting my motorcycle up and running. I rebuilt and installed the carburetors last week. Now working on the front fork springs. As they say its either to many toys not enough time or not toys and too much time. brownc00 MAY 15, 01:03 PM Check the frame really well in the back especially where the control arms for the rear axle bolt up. Jeep added an access hole in the frame for assembly purposes and they rot out really bad in that area because of it. Couple of my local jeep guys have had control arms fall off the frame because of rot. Tstang429 MAY 15, 11:12 PM Yea been over the frame. Has one bad area after the crossmember/ skid plate. other than that not bad. This winter problay going to get frame repaired.