|
84 se bogs when accelerating (Page 2/2) |
|
katie80
|
AUG 02, 10:43 AM
|
|
quote | Originally posted by Patrick:
Although it's not as simple to test as with the 2.8, it would tell you a lot to know what the fuel pressure actually is.
I've had "bogging" issues with my '84 in the past. Here is a thread documenting my experiences. |
|
so I actually did a bit more testing, turns out I had a small vacuum leak, plugged it back in and drove it. drove fine for about 10 minutes but gave me the same code again. got a fuel pressure tester. it's at a solid 11 psi (dips a little when I rev the engine though). is that a good reading?
|
|
|
Patrick
|
AUG 02, 11:37 AM
|
|
quote | Originally posted by katie80:
got a fuel pressure tester. it's at a solid 11 psi (dips a little when I rev the engine though). is that a good reading?
|
|
Specs call for 9-13 psi. How low does it dip?
|
|
|
katie80
|
AUG 02, 02:08 PM
|
|
quote | Originally posted by Patrick:
Specs call for 9-13 psi. How low does it dip?
|
|
only to around 10, nothing major. I just set my ignition timing to 8* as it calls for in the Haynes manual. it wasn't super off but it's correct now. same problem. it doesn't hesitate so much as it bucks now. I step on the gas at all and it just lurches and bucks. it'll only accelerate if I press gently on the gas pedal.
|
|
|
Xenoblast
|
AUG 02, 03:35 PM
|
|
quote | Originally posted by katie80:
only to around 10, nothing major. I just set my ignition timing to 8* as it calls for in the Haynes manual. it wasn't super off but it's correct now. same problem. it doesn't hesitate so much as it bucks now. I step on the gas at all and it just lurches and bucks. it'll only accelerate if I press gently on the gas pedal. |
|
not sure if its the same way on the 4 cylinder fieros, but for the 6 cylinders you need to ground the diagnostics port and the car needs to be warmed up. Did you do this?
|
|
|
katie80
|
AUG 02, 05:28 PM
|
|
quote | Originally posted by Xenoblast:
not sure if its the same way on the 4 cylinder fieros, but for the 6 cylinders you need to ground the diagnostics port and the car needs to be warmed up. Did you do this? |
|
it is the same way, I followed the instructions on the decklid sticker.
|
|
|