The drivers side switch unlocks and locks both doors. The passenger switch does nothing. I replaced the passenger side switch and checked the wires for anything visibly loose, corroded or broken. Does anyone have any idea where I should check next? I also swapped out the relay but still the same.
[This message has been edited by fierosound (edited 08-25-2020).]
theogre
AUG 25, 11:41 PM
Fiero both L-switches run same relays that operate both of L-motors...
P-side switch or wire to it likely bad. Doors have connectors under carpet at A pillar. Check PL circuit there to see if relays work at that point.
------------------ Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should. (Jurassic Park)
The orange/ dk blue wire had no power. The fuse was good so I'm guessing it had broken somewhere in between. I tied the orange at the multiwire connector by the relay to a hot wire and everything is working good. in fact the locks work better than they have in decades. No need to push the button multiple times to lock anymore. thank you everyone for their help. 86 SE with 24k miles
