|
Why is there no information on this forum on how to remove/install side moldings? (Page 1/1) |
|
hypo327
|
OCT 05, 09:32 PM
|
|
I don't like doings anything without checking with folks who have successfully done it before...
|
|
|
ltlfrari
|
OCT 05, 09:43 PM
|
|
|
|
Dennis LaGrua
|
OCT 06, 02:44 PM
|
|
Each molding clip has a holding tab on it. You slightly pull the molding away get under with a small screwdriver, push the tab up and pull away the molding. Before starting its a good idea to put masking tape along the bottom edge of the molding strip to prevent possible scratches cause by the screwdriver. ------------------ " THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite. "THE COLUSSUS" 87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H " ON THE LOOSE WITHOUT THE JUICE "
|
|
|
|