|
Rear cradle/subframe measurements or CADs for pre-88 (Page 1/1) |
|
vortec87
|
NOV 29, 09:40 AM
|
|
I have been searching all over and I would like to know if anyone has the measurements of the rear subframe or even better CAD drawings of it on pre-88 Fieros. I have an 84 SE that I am about to start a serious project on and this information would be very helpful. It seems only the 88's get special CAD treatment, and every post I have found asking about anything pre-88 just points to the FSM and the bolt locations which is not helpful. For inquiring minds I will post what I need to replace my iron duke with.
|
|
|
darbysan
|
NOV 29, 10:40 AM
|
|
|
|
vortec87
|
NOV 30, 09:45 AM
|
|
Those do help a little, thank you
|
|
|
Will
|
NOV 30, 10:08 AM
|
|
The dimensioned drawings are from the FSM. I have never seen dimension data on the control arm pivots.
|
|
|
ragoldsmith
|
DEC 09, 03:04 AM
|
|
quote | Originally posted by vortec87:
I have been searching all over and I would like to know if anyone has the measurements of the rear subframe or even better CAD drawings of it on pre-88 Fieros. I have an 84 SE that I am about to start a serious project on and this information would be very helpful. It seems only the 88's get special CAD treatment, and every post I have found asking about anything pre-88 just points to the FSM and the bolt locations which is not helpful. For inquiring minds I will post what I need to replace my iron duke with. |
|
Wow! Are you going to create a build thread? I definitely want to keep up with this build! If not, I will subscribe here and hope for updates.
|
|
|
vortec87
|
DEC 26, 04:56 PM
|
|
Hopefully, I will have a build thread started in a few weeks. Parts have been slow to show due to COVID.
|
|
|
DimeMachine
|
DEC 26, 05:00 PM
|
|
quote | Originally posted by vortec87:
Hopefully, I will have a build thread started in a few weeks. Parts have been slow to show due to COVID. |
|
Can't wait to see this thread!!
Dime
|
|
|