|
6 speed out of Chevy Cruuize (Page 1/1) |
|
rubyredfiero
|
DEC 01, 02:04 PM
|
|
There is a 2011 Chevy Cruize with the 4 cyl and 6 speed (M32) that is being parted out. 1. Does the trans have the typical V6 bolt pattern? 2. Has anybody swapped the M32 in a Fiero?
I can get the trans, half shafts, spindles, clutch, T/O bearing, flywheel and whatever I need. Unknown what the owner wants for money, so kinda cautious on proceeding. Any help is much appreciated. My 84 Muncie 4 speed just not cutting it cruising outside city limits with the 4.10 final drive behind my stock 5.0L TPI.
|
|
|
fieroguru
|
DEC 01, 03:15 PM
|
|
1. No 2. No[This message has been edited by fieroguru (edited 12-01-2020).]
|
|
|
Gall757
|
DEC 01, 03:50 PM
|
|
quote | Originally posted by rubyredfiero:
My 84 Muncie 4 speed just not cutting it cruising outside city limits with the 4.10 final drive behind my stock 5.0L TPI. |
|
I can imagine.. Any other Fiero transmission would be much better. I would pick the M17.[This message has been edited by Gall757 (edited 12-01-2020).]
|
|
|
rubyredfiero
|
DEC 01, 05:28 PM
|
|
Thanks for the replies. M17 are not easy to find anymore. Probably keep looking for MG2 or F23.
|
|
|
Gall757
|
DEC 01, 06:03 PM
|
|
Here is a good source you probably know about:
https://www.car-part.com/[This message has been edited by Gall757 (edited 12-01-2020).]
|
|
|
pmbrunelle
|
DEC 01, 06:11 PM
|
|
What do you dislike about the M19? Noise? Concerned about wear on the engine? Drinks too much fuel?
I have M19 gearing (in an M17 case), and once I got used to 3240 RPM @ 110 km/h cruise, I found that my V6 Fiero was quite a pleasant highway cruiser. My exhaust/muffler is quiet enough.
Are you ready to accept reduced acceleration?
Anyway, I think that Danyel Potvin may have an M17 for sale. You could send him a PM. As I usually suggest with used parts, dismantle, inspect, and rebuild prior to use.
On car-part.com there are a few F23s around your area: https://www.car-part.com
|
|
|
Rickady88GT
|
DEC 01, 08:28 PM
|
|
quote | Originally posted by rubyredfiero:
There is a 2011 Chevy Cruize with the 4 cyl and 6 speed (M32) that is being parted out. 1. Does the trans have the typical V6 bolt pattern? 2. Has anybody swapped the M32 in a Fiero?
I can get the trans, half shafts, spindles, clutch, T/O bearing, flywheel and whatever I need. Unknown what the owner wants for money, so kinda cautious on proceeding. Any help is much appreciated. My 84 Muncie 4 speed just not cutting it cruising outside city limits with the 4.10 final drive behind my stock 5.0L TPI. |
|
I would do the entire drive train
|
|
|
|