Trying to mate up my MY8 tranny to a 3800SC i could only get in 5 bolts. The one with the dowel on the right (facing the engine) (rear at the motor sits in the car) refused to accept a bolt. i thot the threads were damaged, so i pulled the tranny off the engine only to find that there are no threads, but the bolt will not enter the hole enough to engage, nor does it enter as far as the others. Could it be that the bolt sheared off inside of the block? i do need all 6 bolts to hook the tranny up to the engine no?
jon
olejoedad
MAR 16, 03:19 PM
It is fine without a bolt in it.
Spoon
MAR 16, 07:55 PM
In case you're not aware the MY8 is the economy 4 spd transmission. If you change your mind and decide not to use it let me know and I would gladly take it off your hands and waive the disposal fee.
Spoon
------------------ "Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut
