|
Missing bolt. Size needed please. (Page 1/1) |
|
deezil
|
MAY 26, 09:34 AM
|
|
I lost my Air conditioning manifold bolt that is (was) located on the bulkhead going to the lines running under the car. Does anyone know what size thread and ovelall length I will need to replace this with?
I was working on getting the ac set up again and unfortunately I had it in my motorcycle jacket pocket and it must have fell out on the way to the parts store.
|
|
|
Will
|
MAY 26, 12:21 PM
|
|
The bolt that holds the junction block on the left side of the engine compartment together? That's M8x1.25 x ~40ishmm... Since it goes into a clip nut, you can go over length with no problems.
|
|
|
Will
|
MAY 26, 04:40 PM
|
|
The above is IIRC... the bolt could be an M6. Check out the clip nut. Anti-seize it when you put it back together.
|
|
|
deezil
|
JUN 04, 02:43 PM
|
|
|
|
Mark_j
|
JUN 05, 02:46 AM
|
|
If it is any of the bolts shown in figure F the firewall blocks are M6 and the shield is M8.
|
|
|