Plastic piece on camber bolt (Page 1/1)
cam-a-lot MAY 13, 07:17 AM
Hello

Changing struts, 88 GT

Does anyone know what this plastic piece is for, and if I need to find another one? This is broken.

thanks

[This message has been edited by cam-a-lot (edited 05-13-2022).]

theogre MAY 13, 02:29 PM
Plastic is "Filler" for under size cam bolt that allows Camber adjustment for rear axle.

I don't think this bolt "kit" is OE even for 88.

Many use another type of kit w/ an offset "washer" that is a cam that does same. Because Most Struts are made for this type setup w/ "ears" and slots on one bolt hole, usually lower bolt.
See my Cave, Strut & Shock

⚠️ If has 2 cam bolts in 1 strut...
Something is "wrong" and PO trying to get more Camber adjust.
Good luck figuring out the problem and if needed get new bolt set.

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)

The Ogre's Fiero Cave

fierosound MAY 13, 05:25 PM
There are two different camber kits floating around.
https://www.fiero.nl/forum/...100421-2-093511.html

I prefer using the Spicer / NAPA type.
The adjuster is used in the lower bolt hole.






------------------
My World of Wheels Winners (Click on links below)

3.4L Supercharged 87 GT and Super Duty 4 Indy #163

[This message has been edited by fierosound (edited 05-13-2022).]

cam-a-lot MAY 14, 08:13 AM
Thanks for the replies. I appreciate it