 
     |
| WCF 4t65e-hd shift bracket help (Page 1/1) |
|
MichiganReefer
|
JUN 01, 10:14 PM
|
|
Hey everyone, hoping to find some advice from people who have done the 3800 swap and possibly used the WCF shift bracket for the 4t65e-hd. They provide it undrilled and offer no real instructions on how to determine where to drill the hole. In addition the rectangular hole that fits on the shift pin doesn't fit. Can anyone guide me on how to figure the best spot to drill it? Does this process have to begin once the cradle is in the car and I can put the shift cable into the catch of the bracket? Does anyone have some good pictures of the WCF bracket done properly? I'd appreciate it, I've scoured the forum and haven't been able to find a post talking about it.
Thank you
|
|
|
|
olejoedad
|
JUN 02, 12:40 PM
|
|
|
Please post a picture of their bracket.
|
|
|
|
Dennis LaGrua
|
JUN 02, 03:37 PM
|
|
I've used that WCF Bellcrank device and it works but its quite difficult to measure, locate and drill the main swing lever hole for proper function. Best to wait until everything is in place before drilling the swing lever hole.
------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE " [This message has been edited by Dennis LaGrua (edited 06-02-2023).]
|
|
|
|
MichiganReefer
|
JUN 02, 05:23 PM
|
|
This, unfortunately, isn't the best picture, but I hope it helps. The silver piece has been formed and welded. The linkage is off to the side. 
|
|
|
|
olejoedad
|
JUN 03, 08:00 AM
|
|
I've never used a bellcrank system on a 4T65EHD.
I've always modified the stock cable bracket and shift lever.
|
|
|
|