 
     |
| Foam for seat repair (Page 1/1) |
|
fredtoast
|
JUN 14, 09:46 PM
|
|
Ordered some new seat covers (Iggee), but I am going to need to either add some more foam or completely replace what is there now. Hard to tell until I actually take the seats apart.
Any suggestions on type or specification? I have learned a great new term "Indention Load Deflection" (ILD) which is a measure of firmness. I think I will go with "firm" (45 ILD), although I have seen some "extra-firm" (60 ILD)
I want to just get one big sheet of the stuff because that is by far the cheapest. If I get the one inch thickness can I glue/stack them pretty easily? Or is it better to get something thicker and cut it back if you need thinner?
Any other info/suggestions? I searched, but was surprised that I did not find some detailed, step-by-step thread on this. I am sure this is something a lot of guys have done. If I missed one just post the link.
Thanks
|
|
|
|
IMSA GT
|
JUN 15, 01:29 AM
|
|
|
|
|