new distributor question on internal cap no start (Page 1/1)
Superm1952 APR 06, 08:18 PM
I just replaced my distributor in my 86 GT. I bought it from the fiero store. It has the "star" pattern for the points. My question is There is a copper or bronze colored cover over the stars Does that cover come off or stay on. Every pic I can find has everything exposed and no such cover. I have a no run situation still.?? The car was running fine and then 2 weeks went by and no start. I openned the distributor and found rust heaven!! I ordered a new one and have the same problem. I have replaced the fuel the fuel filter the distributor. The only part is the coil. I did everything by the forum doing all of this. My next chase I guess is the coil?! The only thing I have read that I didnt do was to pull the ECM fuse?? Thanks for any input

Asked what my fuel pump pressure was it is what the book said. I can smell gas after I crank it. I enclosed the pictures so you can see the cap I am asking about.

[This message has been edited by Superm1952 (edited 04-07-2024).]

Patrick APR 06, 08:57 PM

quote
Originally posted by Superm1952:

I openned the distributor and found rust heaven!!





quote
Originally posted by Patrick:

A little bit of rust never hurt nuttin.

Umm... is the inside of the distributor supposed to look like this?






And in case your ignition timing is way off, read This post.


quote
Originally posted by Superm1952:

I have replaced the fuel the fuel filter the distributor. The only part is the coil. I did everything by the forum doing all of this. My next chase I guess is the coil?! The only thing I have read that I didnt do was to pull the ECM fuse??



What's the fuel pressure reading?

[This message has been edited by Patrick (edited 04-06-2024).]

82-T/A [At Work] APR 06, 09:02 PM


quote
Originally posted by Patrick:






Reminds me of the milanesa steaks that my Argentine grandmother used to make!!!




... NOT my grandmothers, or my mom's... they make them WAAAY better than this.