NOW AVAILABLE IN BLUE or GREEN! SEE THE PICS BELOW.







Everthing you see in the above picture is included (GT version shown).











Here in an example of the full Gauge kit in blue except that the gauge below the tach doesn't show up.



Here in an example of the Tach in blue with optional outside air temp gauge.





Sorry some of the pics are a bit blurry or have some glare but it is hard to get a good pic of them


Check out my my web sight at: www.tomsdigitalelectronics.com

If you would like to place an order you can use "buy it now" on my website here:
Buy them here: http://www.tomsdigitalelect...ing_and_base_pricing

DIGITAL GAUGE CONVERSION PACKAGE
FOR ALL 84 - 88 FIERO'S

There are two conversion packages available: GT. and NON GT.

The NON GT. package includes:

?Main dash gauge conversion which includes a red digital Tachometer, Speedometer, Fuel, and Water Temperature gauge. Also, there is either an Oil Pressure or Voltmeter gauge below the tachometer depending on the year of your car.
?Designed by a long time Fiero owner specifically for the Fiero (not from another car).
?They easily mount in side of the factory gauge housing after removing the original gauges.
?Tinted Plexiglas panel to perfectly replace the gray factory panel covering the factory gauges.
?Available in either full English or Metric display versions.
?Factory indicators are retained: turn signal, brake, highbeam, etc..
?Bright red displays for the best contrast in sunlight (green optional or mix the 2 colors as you want).
?Tachometer and Speedometer have a light bargraph that wraps around their digital displays for quick glance readings.
?Factory odometer is retained.
?Complete installation instructions and any needed mounting hardware is included.
?All gauges use the factory sensors for easy installation.
?All Gauges dim when either the parking and/or headlights are turned on.
?Labels for all gauges are lit and they will flash when any readings are out of range (Ex. temp too high, oil press too low, etc?)
?All Microprocessor controlled.
?Lifetime Warranty
?Short installation time of about 3 to 4 hours with minimal modifications (only a few wires to connect and a 1/2? piece of plastic to cut.


The GT. package includes everything that is in the NON GT. version with the addition of:

? Center dash gauge conversion including a digital Volt Meter and Oil Pressure gauge.
? Tinted Plexiglas panel to perfectly replace the gray factory panel covering the factory center gauge.
? Additional installation time of about 1/2 hour.

Note: There will not be any gauge below the tachometer ( as in the NON GT. version ) to match the
factory GT. gauge layout.


Specifications for each individual gauge are as follows:

SPEEDOMETER
? Speedometer will read from 0 MPH to 200 MPH or 0 KPH to 250 KPH for the metric version.
? Reads in 1 MPH or 1 KPH increments.
? Bargragh display is jumper selectable for either 80 MPH or 120 MPH full scale reading. For t the metric version it is selectable for either 130 KPH or 190 KPH full scale reading.


TACHOMETER
? Tachometer will read from 0 RPM to 9900 RPM.
? Reads in 100 RPM increments.
? Tachometer is jumper selectable for use with either a 4, 6, or 8 cylinder engine.
? Bargragh display is jumper selectable for either 5000, 6000, or 7000 RPM full scale reading.


FUEL
? Fuel gauge will read from 0.0 to 9.9 Gallons or 0.0 to 60 Liters.
? Reads in .1 Gallon or 1 Liter increments.
? Full fuel tank reading is adjustable.
? Fuel label will blink when the fuel drops below 2.0 gallons or 7.0 Liters.


WATER TEMPERATURE
? Temperature gauge will read from 80 to 255 F or 30 to 124 C.
? Reads in 5 F increments or 2 C increments.
? Temperature label will blink if the temperature rises above 230 F or 112 C.


OIL PRESSURE
? Oil pressure gauge will read from 0 Psi to 99 Psi or 0 to 9.9 Bar.
? Reads in 1 Psi or .1 Bar increments.
? Oil label will blink if the oil pressure rises above 79 Psi or 7.9 Bar or falls below 16 Psi or 1.6 Bar.


VOLT METER
? Voltmeter will read from 9.5 to 24.0 volts.
? Reads in .1 volt increments.
? Volts label will blink if the voltage rises above 15.4 or falls below 11.6 volts.

Note: These gauges are the same as the gauges offered by Pisa Co. as I sell them to Pisa. The gauges are on Pisa's web sight at: http: http://www.pisafierohq.com/interiors/gauges/.


ABOUT ME (Tom Sweet)

I am an electrical engineer and I designed these gauges 100%, including the circuit boards and software, for my 86-GT V8 Fiero of 18 years. For the past 20+ years I have been offering these gauges to other Fiero owners to enjoy. The pictures you see are the gauges mounted in my Fiero. I am one of the original members of Suncoast Fieros of Florida and have enjoyed many years of driving my V8 Fiero. I have done most of the mods that you can do to a Fiero myself. It really makes those Porsche / Corvette drivers feel bad when I come across them.


COST AND SHIPPING

To place an order call me (tom) at (727) 515-9015 (leave a message if I dont answer and I'll call you back, or e-mail me at: http://www.tbsb9595@att.net

Pricing for the Non GT version is $529 + shipping + options (see below)
Pricing for the GT version is $669 + shipping + options (see below)
Shipping is $15.00 via 2-3 day USPS in continental US or I can ship outside the US for a bit more.


OPTION 1 - If you would like a color other than Red just let me know what you are looking for and I'll give you the price.

OPTION 2 -Extra gauge option (below the Tach for GT versions only) is $69.00 + a sensor. The gauge can just about anything including the following: boost, any temperature, fuel pressure, etc.

OPTION 3 - Matching Plexiglas panel that mounts around the Stereo/AC controls/Vents and also a trim piece that mounts around the shifter area. This will give the same look to the center console as the digital dash provides. For this option add $84.00.

OPTION 4 - Low cost option (partial digital kit) also available. This includes the same items as this auction, minus the digital Tach and Speedo. The plexiglas panels have holes cut out for the analog Tach/Speedo for this version. If you like you can always add the digital Tach and Speedo later. The price for this kit is $299.00.


Individual small gauge prices are:

Fuel/temp - $169
Volts/oil (gt) - $167

You can also go to my web sight at: www.tomsdigitalelectronics.com

Please allow 2 to 4 weeks for the gauges to be shipped, as they are custom built to fit your version of Fiero. I accept Payment via Certified check, Money order, or Paypal.

[This message has been edited by TBSB9595 (edited 11-15-2024).]