86 Fiero SE, I took my suspension apart to replace the upper control are bushings and lost one of the 6 mm spacers. It takes 2 so I'm 1 short. Must of rolled away when I pulled the pin. Looked everywhere. Auto part stores have no clue. One place told me to just stack some washers and get it close!! If someone has a set of 2 that will be better just in case something like this crops up again when I do the other side. My ship zip is 19369.
Thanks
Spoon
------------------ "Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut
Xenoblast
OCT 26, 04:10 PM
I just used a bunch of 7/16th washers (I think), and measured them so that they totalled 12mm
Added benefit is that the caster is fully adjustable, and not just in 6mm increments.
[This message has been edited by Xenoblast (edited 10-26-2022).]
Spoon
OCT 27, 10:14 AM
Nevermind, I found what I needed at the most obvious place. The Fiero Store. $19.xx + shipping.
Spoon
------------------ "Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut
