Full set of molds to build a Custom 288 GTO (Page 1/1) dobie1 SEP 25, 09:34 PM Up for sale is a complete set of molds to produce my car, I designed and built this car over the last 8 years. I believe there are enough differences in my design that big red can’t say it theirs. I was going to produce and sell roller cars with the bodies already mounted but I turn 72 this month and I just don’t have the drive. I’m asking $20,000 for the set of molds the buyer is responsible to for any costs in shipping. They are well built quality molds that I used to pull the body panels to produce this car. They have wide flanges to allow for carbon fiber infusion to produce CF bodies. It comes with a rotisserie mobile mount that I designed to facilitate ease laying up the rear body half. There are approximately 20 mold parts that make up the body panels. Here are a few specs of the finished car compared to the GTO My car was built was built on a unstretched 93.5” Fiero frame vs 96.5 OEM GTO My car is 173” long vs 169” OEM GTO My car is 78” wide vs 75” OEM GTO it does require a widened suspension. I believe the body could be attached to other mid engine donor cars with some fabrication and mods. I will work with the buyer to help facilitate the shipping. If your interested in the molds please message me and we can forward contact information. Thanks for looking Wayne I pulled the first set of panels from my molds and built this car. Spadesluck SEP 26, 10:49 AM I usually dislike any of the rebodies I have seen, however this looks great! Is that your red car in the pics then? dobie1 SEP 26, 08:59 PM quote Originally posted by Spadesluck: I usually dislike any of the rebodies I have seen, however this looks great! Is that your red car in the pics then? Yes it was built using the fiberglass panels I layed up in the molds. The full build for the car is in the Construction Zone 288 GTO build. Thanks for the compliment!! Wayne