 
     |
| WTB lower control arm for 88 pass side (Page 1/1) |
|
ricreatr
|
JUN 27, 09:19 AM
|
|
|
Looking for one in just about any shape. thanks
|
|
|
|
NewDustin
|
JUN 27, 10:38 AM
|
|
I believe The Fiero Store has them, if there are any cores available:
https://www.fierostore.com/...088RHFTLWR&d=339&p=1
Have you tried reaching out to them?
I've also had a fair amount of luck with Lonni at the Fiero Club (https://g.co/kgs/nNjMuuF) here in Vegas, and know that The Fiero Factory (https://thefierofactory.com/) has a good amount of parts too!
|
|
|
|
richard in nc
|
JUN 27, 07:26 PM
|
|
|
i assume you mean for the front?
|
|
|
|
NewDustin
|
JUN 28, 12:39 AM
|
|
| quote | Originally posted by richard in nc:
i assume you mean for the front? |
|
This is a good point. I just rebuilt both of my rear lateral control arms following fieroguru's instructions. ricreatr, you could probably just do the same if you mean the rear  [This message has been edited by NewDustin (edited 06-28-2024).]
|
|
|
|
ricreatr
|
JUN 28, 12:07 PM
|
|
was after the front. hmmmm guru has instructions on the rears eh? i just rebuilt my other fiero with rodney bushings etc. went very nicely.
the $220 from the fiero store really makes me question the quality of the new ones being sold. Could not find info here on a search for them. i assume they are china, but also $220. ????
|
|
|
|
Larryinkc
|
JUN 28, 01:11 PM
|
|
|
|
|
NewDustin
|
JUN 28, 03:20 PM
|
|
That's a cool site; I hadn't seen it before!
At $223/arm you almost might as well go with the tubular arms from WCF, though.
|
|
|
|
Larry Hubbert
|
JUN 28, 07:33 PM
|
|
 I have a pair that I will be removing from an 88 GT I am parting out. Normally I remove them, power wash and steam clean them before having them media blasted before selling them however if you need them fast I can forgo those steps and pull them off, do a quick clean up and ship them if you are interested. If so please PM me on here or DM me on Facebook Messenger. Thanks.
|
|
|
