just got a new spec3 clutch to bolt up to my 3800 flywheel for my swap, looking for "factory" torque specs for I guess a 2.8.

control arm stud pinch bolt
1. 84-85.....30-36lbs
2. 86-87.....37lbs
flywheel to crankshaft bolt.....50lbs
clutch pressure plate to flywheel bolt.....15lbs
clutch pedal assembly to cowl.....13lbs
hydraulic line to clutch master cylinder.....13lbs
clutch master cylinder to cowl nuts.....13lbs
hydraulic line to clutch slave cylinder.....12-13lbs
clutch release lever to clutch fork bolt/nut.....20lbs
clutch slave cylinder to slave cylinder bracket nuts.....20lbs
slave cylinder bracket to transaxle.....32lbs

Thanks, we couldnt find it in our chiltons for some reason.

I strongly reccomend going out and getting some 10.9 bolts for the pressure plate. They're 8x1.25 (IIRC) and available anyplace like lowes. I got a little over zealous with the pressure plate once and snapped a bolt off in it (I dont think I was even that high above 35) but these would be cheap cheap insurance, especialy considering all the heat the things take. Dont forget new lock washers too.