Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Rear Cradle Bolt Spins (with a good pic!) (Page 2)

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version

This topic is 2 pages long:  1   2 
Previous Page | Next Page
Rear Cradle Bolt Spins (with a good pic!) by Saxman
Started on: 05-09-2007 10:52 PM
Replies: 44
Last post by: arte444 on 07-25-2008 10:51 AM
Saxman
Member
Posts: 5151
From: Melbourne, FL
Registered: May 2005

Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member
Report this Post11-24-2007 02:07 PM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
 
quote
Originally posted by Taijiguy:
That Fiero makes your butt look big....


Quit looking at my azz...
IP: Logged
Saxman
Member
Posts: 5151
From: Melbourne, FL
Registered: May 2005

Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member
Report this Post07-21-2008 10:30 PM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
Well, I'm about to take out this 2.8 to install a new 3.4. I guess it sat too long before I put it in because I hear a knock...

Here we go again!
IP: Logged
arte444
Member
Posts: 1510
From: Minnesota
Registered: Sep 2002

Feedback score: (2)
Leave feedback





Total ratings: 151
Rate this member
Report this Post07-22-2008 01:37 PM Click Here to See the Profile for arte444Send a Private Message to arte444Direct Link to This Post
Good trick for removing and installing cradle bolts is using the weight of the engine + jamming it with a screwdriver.
IP: Logged
Saxman
Member
Posts: 5151
From: Melbourne, FL
Registered: May 2005

Feedback score:    (8)
Leave feedback





Total ratings: 114
Rate this member
Report this Post07-22-2008 06:45 PM Click Here to See the Profile for SaxmanClick Here to visit Saxman's HomePageSend a Private Message to SaxmanDirect Link to This Post
I tried using the weight of the engine before, but never thought of shoving a screwdriver in there to help. Thanks!
IP: Logged
arte444
Member
Posts: 1510
From: Minnesota
Registered: Sep 2002

Feedback score: (2)
Leave feedback





Total ratings: 151
Rate this member
Report this Post07-25-2008 10:51 AM Click Here to See the Profile for arte444Send a Private Message to arte444Direct Link to This Post
Since you have a window cut out already, a permanent solution would be better than my little trick since the nut plate can be hard to locate in the hole again once the bolt is removed.
IP: Logged
Previous Page | Next Page

This topic is 2 pages long:  1   2 

All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock