Replacement of Stainless Steel Coolant Tube - Tubes - Pipe (1.5" SS Custom Fabbed)

Click here to visit the donation page | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

Replacement of Stainless Steel Coolant Tube - Tubes - Pipe (1.5" SS Custom Fabbed) (Page 2)

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

This topic is 2 pages long: 1 2
Previous Page | Next Page

Replacement of Stainless Steel Coolant Tube - Tubes - Pipe (1.5" SS Custom Fabbed) by 4LB21HP

Started on	: 06-13-2007 05:25 AM
Replies	: 43
Last post by	: rkisling on 05-18-2008 03:32 PM

4LB21HP
Member

Posts: 58
From: Roseville, CA, USA
Registered: Oct 2005

Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-06-2008 03:33 AM

Thank you guys for your support!!! You spend what seems like forever planning these upgrades and it is great having people compliment them once you finally get them together! On to answering your questions...

Saxman: I got the blue silisone connectors off of ebay. They are 1.5" dia. and are called silicone hump hose. They allow more flex.

88Formula327: The spacers are only there for convience. If I pull the engine and transmission by droping the cradle the coolant crossover has to be removed because of clearance with the frame rail. The spacers have O-rings built into them so that they do not need gaskets or any RTV! Just take out the bolts and put them back in and ready to go.

Thanks for the compliments once again!

IP: Logged

4LB21HP
Member

Posts: 58
From: Roseville, CA, USA
Registered: Oct 2005

Feedback score: N/A
Leave feedback

Rate this member

Report this Post03-06-2008 03:52 AM

Ok, I didn't want to release this picture until I got my fuel injection installed, but I'm going to post it early. Let me know what ya think of the valve covers and the breather....