Which direction does the fuel filter go on for the Flow in the right directions could someone show me a picture

If you're talking about a V6, the arrow points to the outside of the car.

Well now i found out which direction but do i need O ring or washers that go in the ends??

the arrow always points towards the motor. you gotta then crank it a bit to build up enough fuel to start the car. if its backwards, no amount of cranking will start the car.

Ok thanks guys. now im having trouble with it leaking the inside nut that screws in is rusted on and wont move the other side is fine and unscrews fine what should i do and plus its leaking on the side that wont turn.... Should i Get 0 Rings or washers??? are they needed or what are the steps i need to do cuz i already have it off and everything just one end is stuck and its leaking....

Did you soak the fittings with PB Blaster before trying to loosen them? If not do it now.
Please be carful with the leaking gas.

I believe it's a compression fitting and there are no separate washers or O-rings.

When I removed mine, I sprayed the fittings with PB Blaster and let it soak in before trying to loosen the fittings. I didn’t want to end up twisting and/or damaging the metal lines. Make sure you use TWO wrenches (one on each "nut") on each side of the filter when loosening/tightening. Upon reassembly, I put anti-seize on the threads.

[This message has been edited by Patrick (edited 11-10-2008).]

No i havent What are some things i need to watch out for ??? and what do i need to do besides put the new one back basically im reading what the book has told me so it would prob be better to get some info on this so im listening