Ok, I have been searching the forums and Googling and can not seem to find what I am looking for.

What do I configure in WinADL for a 1986 Fiero 2.8. In my searching, I found that the ECM for the 86' Fiero is unique to this car, and not used in other vehicles.

Also, the ECM in the fiero's is 4800 baud, or 2400?

I was thinking that there would be a list or something on the forums as to what settings in WinALDL settings to use for each year and engine ect.

It's not like WinADL has vehicle make and year to select from

Any suggestions?

[This message has been edited by JohnWPB (edited 07-10-2010).]

The 85 V6 Fiero uses a single year specific ECM. The last 4 digits are 6869.
The 86-88 V6 Fiero uses the 7170 ECM.

You can probably set the baud rate for 2400. In reality, the Fiero's data port runs at 190 baud. (Seriously.)

Cool, thanks! I will give that a try and report back.